Effect of Ply Drop in Aerospace Composite Structures
Author:
- 9 June 2020
- journal article
- research article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 847, 46-51
Abstract
In most of the aerospace laminated composite structures, thickness variation is achieved by introducing the ply drops at the appropriate locations. Ply drop means the resin rich regions created due to abrupt ending of individual plies within the set of plies. This research is focused on understanding and quantifying the effect of these ply drop regions on the mechanical performance of the aerospace composite structures. This is achieved here by designing the appropriate coupons (with and without ply drops) and analyzing them using finite element analysis. Some typical designs of coupons were manufactured using aerospace grade carbon composite materials, and then tested under four-point bend, cantilever and short beam shear tests to check and validate the effect that was seen in the analysis. It is concluded here that allowable failure strains are different for with and without ply drop cases by a significant amount.Keywords
This publication has 9 references indexed in Scilit:
- A simplified layered beam approach for predicting ply drop delamination in thick composite laminatesMaterials & Design, 2016
- Effect of ply-drop on fatigue life of a carbon fiber composite under a fighter aircraft spectrum load sequenceComposites Part B: Engineering, 2016
- Influence of ply-drop location on the fatigue behaviour of tapered composites laminatesProcedia Engineering, 2010
- Simple and efficient interlaminar stress analysis of composite laminates with internal ply-dropComposite Structures, 2008
- Mechanisms and Structural Parameters Affecting the Interlaminar Stress Field in Laminates with Ply Drop-offsJournal of Composite Materials, 2006
- Compressive strength of composite laminates with terminated internal pliesComposites Part A: Applied Science and Manufacturing, 2005
- Analysis of laminates with ply dropsComposites Science and Technology, 2001
- Design guidelines for ply drop-off in laminated composite structuresComposites Part B: Engineering, 2001
- Design and manufacturing considerations for ply drops in composite structuresComposites Part B: Engineering, 1999