A laboratory study of Equotip surface hardness measurements on a range of sandstones: What influences the values and what do they mean?
- 21 January 2019
- journal article
- research article
- Published by Wiley in Earth Surface Processes and Landforms
- Vol. 44 (7) , 1419-1429
Abstract
The Equotip rebound tester is a simple, non‐destructive technique to measure the surface hardness of materials. Having a low impact energy gives the Equotip advantages over the commonly used Schmidt Hammer on weathered rock and stone. In this study we have investigated the influence of different parameters (sample size, moisture content and surface roughness) on the surface hardness values obtained from freshly cut blocks of four types of sandstone. In a series of laboratory experiments both Single Impacts (SIM) and Repeat Impacts (RIM) methods have been used with C and D probes (which have different impact energies). Our results show that whilst sample size is of great importance we find that smaller samples can be reliably evaluated than previously reported. Moisture contents are also found to exert a more important influence on both SIM and RIM results than previously thought, with up to 26% lower hardness values recorded on saturated vs dry sandstone. Conversely, we find that surface roughness (over Sz values of 100 to 800 microns) does not have a significant impact on SIM measurements collected using the D probe. Both SIM and RIM data are found to be good proxies for compressive strength and open porosity, with SIM data collected with the C probe showing the best fits. Data collected using 3D microscopy helps visualize and quantify the small impact marks created by the Equotip and confirms that these are much reduced when using the C vs D probe. The results highlight the benefits of the Equotip to studies of the nature and deterioration of sandstone, the need for careful evaluation of any confounding factors which might influence the values obtained, and illustrate the different advantages of C and D probes. © 2019 John Wiley & Sons, Ltd.Keywords
This publication has 24 references indexed in Scilit:
- The Leeb Hardness Test for Rock: An Updated Methodology and UCS CorrelationRock Mechanics and Rock Engineering, 2017
- A non-destructive tool for detecting changes in the hardness of engineering materials: Application of the Equotip durometer in the coastal zoneEngineering Geology, 2013
- Impact of cement repointing on rates of sandstone decay in medieval churches of the French Massif CentralGeological Society, London, Special Publications, 2013
- Characterization of abrasion surfaces in rock shore environments of NW SpainGeo-Marine Letters, 2012
- Estimating the unconfined compressive strength of intact rocks from Equotip hardnessBulletin of Engineering Geology and the Environment, 2007
- A new technique for non‐destructive field measurement of rock‐surface strength: an application of the Equotip hardness tester to weathering studiesEarth Surface Processes and Landforms, 2007
- The Development of Property Evaluation Method for Rock Materials Based on the Simple Rebound Hardness Test. Investigations on the Effects of Test Conditions and Fundamental Properties.Journal of the Japan Society of Engineering Geology, 2000
- Spherical indentation of elastic–plastic solidsProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 1999
- Sensitivity of sandstone strength and deformability to changes in moisture contentQuarterly Journal of Engineering Geology, 1992
- Use of the schmidt test hammer to detect enhanced boulder weathering under late‐lying snowpatchesEarth Surface Processes and Landforms, 1990