Entrance flow of unfoamed and foamed Herschel–Bulkley fluids
Open Access
- 1 November 2021
- journal article
- research article
- Published by Society of Rheology in Journal of Rheology
- Vol. 65 (6) , 1155-1168
Abstract
The present study investigates extrusion processing of unfoamed and foamed cocoa butter (CB) crystal-melt suspensions (CMSs) with varying crystal volume fraction ΦSFC. Capillary rheometry derived flow curves were fitted with the Herschel–Bulkley–Papanastasiou (HBP) model, and the derived yield stress to wall shear stress ratio τ0/τw of CB CMSs was compared for the various ΦSFC. Foamed CB CMSs behaved fluidlike for ΦSFC≤11.9% and according to a brittle porous solid for ΦSFC>11.9%. The dimensionless entrance pressure loss nen/α as a function of dimensionless shear stress τ∗ was higher for foamed compared to unfoamed CB CMSs at ΦSFC≤11.9% and lower for foamed compared to unfoamed CB CMSs at ΦSFC>11.9%. The ΦSFC dependent difference in nen/α was attributed to the crystal confinement in the die entrance flow, which is increased in the case of elastic gas bubble deformation and decreased in the case of plastic gas pore collapse. The computational fluid dynamics simulated flow of unfoamed and foamed CB CMSs through an abrupt circular 20:1 contraction with the HBP model was compared with the experimental results from quantitative entrance flow visualization (QEFV). Furthermore, the QEFV derived half center incidence angle θ as well as the entrance flow shear and elongational rates γ˙ef and ϵ˙ef were derived and used to establish a model predicting the Bagley entrance pressure loss ΔPBag and calculate an entrance flow characteristic shear and elongational viscosities ηefs and ηefe.Keywords
Funding Information
- Schweizerischer Nationalfonds zur Förderung der Wissenschaftlichen Forschung (20B2-1-180971/1)
- Innosuisse, Schweizerische Agentur für Innovationsförderung (20B2-1-180971/1)
This publication has 47 references indexed in Scilit:
- Apparent elongational yield stress of soft matterJournal of Rheology, 2013
- Aqueous-based extrusion of high solids loading ceramic pastes: Process modeling and controlJournal of Materials Processing Technology, 2009
- On the determination of yield surfaces in Herschel–Bulkley fluidsJournal of Rheology, 1999
- Flow simulation of herschel‐bulkley fluids through extrusion diesThe Canadian Journal of Chemical Engineering, 1993
- Laminar jets of Bingham‐plastic liquidsJournal of Rheology, 1990
- Foam Rheology: III. Measurement of Shear Flow PropertiesJournal of Rheology, 1988
- Fracture toughness of brittle cellular solidsScripta Metallurgica, 1984
- The end correction for power-law fluids in the capillary rheometerJournal of Non-Newtonian Fluid Mechanics, 1978
- Entrance flows of polymeric materials: Pressure drop and flow patternsPolymer Engineering & Science, 1970
- End Correction for Slow Viscous Flow through Long TubesThe Physics of Fluids, 1962