The Hencky equivalent strain and its inapplicability to the interpretation of torsion testing experiments
Authors:
- 11 April 2012
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 92 (18) , 2313-2328
Abstract
Experiments were carried out on a 0.06%C plain C steel to determine the shear stress–shear strain behaviour. The results obtained at 1200°C and a shear strain rate of 0.866 s−1 are described. The experimental data are converted into equivalent stress–equivalent strain form using the von Mises and Hencky formalisms. It is shown that when the equivalent stress is of interest, as in the calculation of rolling load, only the von Mises formulation can be used without the introduction of large errors. This is required so that the incremental work done/unit volume of material can remain constant in both the shear and equivalent uniaxial tension formulations. The problem with the Hencky formalism with regard to simple shear is that the orientations of the Hencky principal strains and principal strain increments do not coincide and also vary continuously. As a consequence, the absolute values of the strain increments cannot simply be summed and the description of the equivalent strain applicable to large strain torsion proposed by Onaka [Philos. Mag. Lett. 90 (2010) p.633] cannot be used to predict mechanical properties along other strain or loading paths. The problems associated with the definitions of the Hencky equivalent stress and Hencky work increment are also discussed.Keywords
This publication has 10 references indexed in Scilit:
- A comparison of the von Mises and Hencky equivalent strains for use in simple shear experimentsPhilosophical Magazine, 2012
- Equivalent strain in simple shear deformation described by using the Hencky strainPhilosophical Magazine Letters, 2010
- Mathematical Modelling of Mean Flow Stress during the Hot Strip Rolling of Multiply-alloyed Medium Carbon Steels.ISIJ International, 1998
- Mathematical Modeling of the Mean Flow Stress, Fractional Softening and Grain Size during the Hot Strip Rolling of C-Mn Steels.ISIJ International, 1996
- Mathematical Modeling of Mean Flow Stress during the Hot Strip Rolling of Nb Steels.ISIJ International, 1996
- Determination of Recrystallization Stop Temperature from Rolling Mill Logs and Comparison with Laboratory Simulation Results.ISIJ International, 1994
- Modeling of flow stress and rolling load of a hot strip mill by torsion testing.ISIJ International, 1989
- Equivalent strain in large deformation torsion testing : Theoretical and practical considerationsJournal of the Mechanics and Physics of Solids, 1982
- The Use of Torsion Testing to Assess Material Formability1982
- Plastic Behavior of Metals in the Strain-Hardening Range. Part IJournal of Applied Physics, 1937