Modelling of loss mechanisms in a pushing metal V-belt continuously variable transmission. Part 1: Torque losses due to band friction
- 1 November 2004
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 218 (11) , 1269-1281
Abstract
The power transmission efficiency of continuously variable transmissions (CVTs) based on the pushing metal belt is acknowledged to be lower than that of discrete ratio alternatives. This tends to negate the potential fuel economy benefits that are obtained by improved engine/load matching with a CVT. This series of three papers details an investigation into the loss mechanisms that occur within the belt drive as a first step to obtaining improvements in efficiency. Experimental work has been undertaken to investigate the no-load and low-load torque losses associated with a pushing metal V-belt CVT. This first paper describes a new analysis of the principal torque losses occurring in the metal belt CVT due to relative motion occurring between the belt segments and bands. The work takes into account new findings in other research and changes in the design of the metal V-belt. The torque loss model proposed in this paper is supported by experimental data from several different test procedures. A number of additional torque loss mechanisms, due to pulley deflections, are described in Part 2 of the series. The findings from this current paper support an analysis of belt-slip losses, which is described in detail in Part 3.Keywords
This publication has 10 references indexed in Scilit:
- Shifting Mechanisms and Variation of Frictional Coefficients for CVT Using Metal Pushing V-BeltsSAE International Journal of Advances and Current Practices in Mobility, 2000
- A Study on the Torque Capacity of a Metal Pushing V-Belt for CVTsSAE International Journal of Advances and Current Practices in Mobility, 1998
- Mechanism of metal pushing beltJSAE Review, 1995
- A Study on a Metal Pushing V-Belt Type CVT (Part 4: Forces Act on Metal Blocks when the Speed Ratio is Changing)SAE International Journal of Advances and Current Practices in Mobility, 1995
- Assessment of Titanium Alloy on Polyethylene Bearing Surfaces in Retrieved Uncemented Total Hip ReplacementsProceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine, 1994
- A Study on a Metal Pushing V-Belt Type CVT (Part 3: What Forces Act on Metal Blocks?)SAE International Journal of Advances and Current Practices in Mobility, 1994
- Modelling of the Steel Pushing V-Belt Continuously Variable TransmissionProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 1994
- A Study of a Metal Pushing V-Belt Type CVT-Part 1: Relation Between Transmitted Torque and Pulley ThrustSAE International Journal of Advances and Current Practices in Mobility, 1993
- A Study of a Metal Pushing V-Belt Type CVT-Part 2: Compression Force Between Metal Blocks and Ring TensionSAE International Journal of Advances and Current Practices in Mobility, 1993
- Aspects of a metal Pushing V-Belt for Automotive Cut ApplicationSAE International Journal of Advances and Current Practices in Mobility, 1988