Pulsating minimum quantity lubrication assisted high speed turning on bio-medical Ti-6Al-4V ELI Alloy: An experimental investigation
Authors:
- 1 January 2020
- journal article
- research article
- Published by EDP Sciences in Mechanics & Industry
- Vol. 21 (6) , 625
Abstract
Machining of bio-medical Ti-6Al-4V ELI grade is categorized in difficult to cut metal alloys due to its lower thermal conductivity and highly reactive in nature at elevated temperature. However, to improve the machinability of this alloy, controlling the temperature during cutting action is a challenging task. On this context, current work introduced a novel cooling strategy named as pulsating minimum quantity lubrication technique to investigate the surface roughness, surface texture (surface topology, surface profile, amplitude distribution curve, Bearing area curve, and Power spectrum), tool-work temperature, and flank wear in high-speed CNC turning of Ti-6Al-4V ELI Alloy. Feed is the leading influencing term towards surface roughness, pulse time contributing the highest impact towards tool-work temperature while flank wear is largely influenced by cutting speed. Abrasion, notch wear, adhesion and diffusion mode of wear is found.Keywords
Funding Information
- There is no funding for this research work
This publication has 28 references indexed in Scilit:
- Influence mechanism of morphological parameters on tribological behaviors based on bearing ratio curveTribology International, 2017
- Quantitative characterization of surface topography using spectral analysisSurface Topography: Metrology and Properties, 2017
- Effect of time-controlled MQL pulsing on surface roughness in hard turning by statistical analysis and artificial neural networkThe International Journal of Advanced Manufacturing Technology, 2017
- Analysis of surface roughness and cutting force during turning of Ti6Al4V ELI in dry environmentInternational Journal of Industrial Engineering Computations, 2016
- On Cutting Temperature Measurement During Titanium Machining With an Atomization-Based Cutting Fluid Spray SystemJournal of Manufacturing Science and Engineering, 2015
- Cutting Temperature Measurement During Titanium Machining With an Atomization–Based Cutting Fluid (ACF) Spray System2013
- A Study on the Cutting Characteristics and Detection of the Abnormal Tool State in Turning of Ti-6Al-4V ELIApplied Mechanics and Materials, 2013
- Evaluation of PVD-Inserts Performance and Surface Integrity when Turning Ti-6Al-4V ELI under Dry MachiningAdvanced Materials Research, 2011
- The dependence of tool overhang on surface quality and tool wear in the turning processThe International Journal of Advanced Manufacturing Technology, 2010
- The Effect of Dry Machining on Surface Integrity of Titanium Alloy Ti-6Al-4V ELIJournal of Applied Sciences, 2008