Position Self-Sensing Evaluation of Novel CW-IPMSMs With an HF Injection Method
Authors:
- 13 March 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 50 (5) , 3325-3334
Abstract
This paper introduces two different novel designs of interior permanent-magnet synchronous machines with concentrated windings, which are attractive to a self-sensing control system. The new machines have some advantages: lower subharmonics of air-gap flux density and magnetomotive force and lower machine losses, including eddy current losses. The machines have been adapted for self-sensing applications by using a high-frequency (HF) injection method. The main machine parameters affecting the estimation accuracy are analyzed such as fundamental frequency saliencies, cross saturation, HF inductance, HF resistance, and harmonic distortion due to multisaliencies. The experimental results verify that the novel machines can reach very high performance with good self-sensing properties regarding the accuracy of the estimated position/speed of electric drives even without the multisaliency decoupling compensation method.Keywords
Funding Information
- China Scholarship Council
This publication has 18 references indexed in Scilit:
- Arbitrary injection for permanent magnet synchronous machines with multiple saliencies2013
- Sensorless control of a novel IPMSM based on high-frequency injection2013
- Position Self-Sensing Evaluation of a FI-IPMSM Based on High-Frequency Signal Injection MethodsIEEE Transactions on Industry Applications, 2013
- Analysis of Iron and Magnet Losses in Surface-Permanent-Magnet Machines Resulting From Injection-Based Self-Sensing Position EstimationIEEE Transactions on Industry Applications, 2012
- Saliency-based sensorless predictive torque control with reduced torque rippleIEEE Transactions on Power Electronics, 2012
- Eddy current loss minimization in rotor magnets of PM machines using high-efficiency 12-teeth/10-slots winding topology2011
- Self-Sensing Comparison of Fractional Slot Pitch Winding Versus Distributed Winding for FW- and FI-IPMSMs Based on Carrier Signal Injection at Very Low SpeedIEEE Transactions on Industry Applications, 2010
- Modeling and Adaptive Decoupling of High-Frequency Resistance and Temperature Effects in Carrier-Based Sensorless Control of PM Synchronous MachinesIEEE Transactions on Industry Applications, 2009
- Accuracy, Bandwidth, and Stability Limits of Carrier-Signal-Injection-Based Sensorless Control MethodsIEEE Transactions on Industry Applications, 2007
- Comparison of carrier signal voltage and current injection for the estimation of flux angle or rotor position2002