Shoe-Surface Friction Influences Movement Strategies during a Sidestep Cutting Task
- 3 March 2010
- journal article
- research article
- Published by SAGE Publications in The American Journal of Sports Medicine
- Vol. 38 (3) , 478-485
Abstract
Background: Increasing the coefficient of friction of the shoe-surface interaction has been shown to lead to increased incidence of anterior cruciate ligament (ACL) injuries, but the causes for this increase are unknown. Previous studies indicate that specific biomechanical measures during landing are associated with an increased risk for ACL injury. Hypothesis: At foot contact during a sidestep cutting task, subjects use different movement strategies for shoe-surface conditions with a high coefficient of friction (COF) relative to a low friction condition. Specifically, the study tested for significant differences in knee kinematics, external knee moments, and the position of the center of mass for different COFs. Study Design: Controlled laboratory study. Methods: Twenty-two healthy subjects (11 male) were evaluated performing a 30° sidestep cutting task on a low friction surface (0.38) and a high friction surface (0.87) at a constant speed. An 8-camera markerless motion capture system combined with 2 force plates was used to measure full-body kinematics, kinetics, and center of mass. Results: At foot contact, subjects had a lower knee flexion angle (P = .01), lower external knee flexion moment (P < .001), higher external knee valgus moment (P < .001), and greater medial distance of the center of mass from the support limb (P < .001) on the high friction surface relative to the low friction surface. Conclusion: The high COF shoe-surface condition was associated with biomechanical conditions that can increase the risk of ACL injury. The higher incidence of ACL injury observed on high friction surfaces could be a result of these biomechanical changes. The differences in the biomechanical variables were the result of an anticipated stimulus due to different surface friction, with other conditions remaining constant. Clinical Relevance: The risk analysis of ACL injury should consider the biomechanical movement changes that occur for a shoe-surface condition with high friction.Keywords
This publication has 40 references indexed in Scilit:
- A Randomized Controlled Trial to Prevent Noncontact Anterior Cruciate Ligament Injury in Female Collegiate Soccer PlayersThe American Journal of Sports Medicine, 2008
- Prevention of anterior cruciate ligament injury in the female athleteBritish Journal of Sports Medicine, 2007
- Deficits in Neuromuscular Control of the Trunk Predict Knee Injury RiskThe American Journal of Sports Medicine, 2007
- The influence of deceleration forces on ACL strain during single-leg landing: A simulation studyJournal of Biomechanics, 2007
- A Markerless Motion Capture System to Study Musculoskeletal Biomechanics: Visual Hull and Simulated Annealing ApproachAnnals of Biomedical Engineering, 2006
- Sport-Dependent Variations in arm Position during Single-Limb Landing Influence Knee LoadingThe American Journal of Sports Medicine, 2005
- A quantitative analysis of valgus torque on the ACL: A human cadaveric studyJournal of Orthopaedic Research, 2003
- Football Cleat Design and Its Effect on Anterior Cruciate Ligament InjuriesThe American Journal of Sports Medicine, 1996
- Osteoarthritis of the knee after injury to the anterior cruciate ligament or meniscus: the influence of time and ageOsteoarthritis and Cartilage, 1995
- Combined knee loading states that generate high anterior cruciate ligament forcesJournal of Orthopaedic Research, 1995