Investigation of hole roundness-error using different electrolytes in STED process
- 29 December 2021
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 37 (12) , 1405-1421
Abstract
Shaped-Tube Electrolytic Drilling (STED) is an electrochemical dissolution-based process able to fabricate high aspect-ratio (AR) holes rapidly on the superalloys. The electrolyte flowing in the side gap between the tool’s lateral surface and hole wall in the presence of an electric field during the entire process duration leads to non-uniform dissolution and stray-cutting. The localization of anodic dissolution mitigates the stray cutting, which contributes to the non-uniformity of micro-holes. The enhanced localized anodic dissolution is attainable by using neutral electrolytes mixed with the alkaline electrolytes that promote passivation on the surface of Inconel 718. The hole roundness error is crucial for the dimensional accuracy of micro-holes due to the overcutting constraints. Therefore, the present research investigates the feasibility of using electrolyte solutions of dissimilar anionic activity mixed with alkaline electrolytes to mitigate hole roundness error in high AR micro-holes. The effects of process parameters, such as applied voltage, tool feed rate, supplementary electrolyte concentration, and electrolyte entry temperature on the hole roundness error were studied to understand the dissolution behavior with different electrolyte solutions. The investigation results revealed that adding alkaline electrolytes in NaCl and NaNO3 based electrolyte solutions mitigate hole roundness error, whereas the KBr-based electrolyte solution performs unsatisfactorily.Keywords
This publication has 33 references indexed in Scilit:
- Reduction of stray corrosion by using iron coating in NaNO3 solution during electrochemical machiningThe International Journal of Advanced Manufacturing Technology, 2014
- Sidewall Insulation of Microtool for Electrochemical Micromachining to Enhance the Machining AccuracyMaterials and Manufacturing Processes, 2014
- Analysis of contoured holes produced using STED processThe International Journal of Advanced Manufacturing Technology, 2008
- Time averaged temperature calculations in pulse electrochemical machining, part II: numerical simulationJournal of Applied Electrochemistry, 2008
- Predicting radial overcut in deep holes drilled by shaped tube electrochemical machiningThe International Journal of Advanced Manufacturing Technology, 2007
- Stray current attack and stagnation zones in electrochemical drillingThe International Journal of Advanced Manufacturing Technology, 2005
- High‐Temperature Electrochemistry: A ReviewElectroanalysis, 2004
- The development of the Arrhenius equationJournal of Chemical Education, 1984
- Density, viscosity, and electrolytic conductivity of concentrated aqueous electrolyte solutions at several temperatures. Alkaline-earth chlorides, lanthanum chloride, sodium chloride, sodium nitrate, sodium bromide, potassium nitrate, potassium bromide, and cadmium nitrateJournal of Chemical & Engineering Data, 1984
- Film Breakdown on Nickel under Transpassive Dissolution Conditions in Sodium Nitrate SolutionsJournal of the Electrochemical Society, 1977