Manufacturing and testing of ITER-like divertor plasma facing mock-ups for DEMO
Authors:
- Eliseo ViscaEVEliseo Visca
- B. BöswirthBBB. Böswirth
- E. CacciottiECE. Cacciotti
- V. CerriVCV. Cerri
- F. CrescenziFCF. Crescenzi
- F. GallayFGF. Gallay
- H. GreunerHGH. Greuner
- A. RealeARA. Reale
- M. RichouMRM. Richou
- S. RoccellaSRS. Roccella
- J.H. YouJYJ.H. You
- F. MavigliaFMF. Maviglia
- 1 November 2018
- journal article
- conference paper
- Published by Elsevier in Fusion Engineering and Design
- Vol. 136, 1593-1596
Abstract
No abstract availableKeywords
This publication has 9 references indexed in Scilit:
- Potential approach of IR-analysis for high heat flux quality assessment of divertor tungsten monoblock componentsFusion Engineering and Design, 2017
- ITER-like divertor target for DEMO: Design study and fabrication testFusion Engineering and Design, 2017
- Structural impact of armor monoblock dimensions on the failure behavior of ITER-type divertor target components: Size mattersFusion Engineering and Design, 2016
- European DEMO divertor target: Operational requirements and material-design interfaceNuclear Materials and Energy, 2016
- Design study of ITER-like divertor target for DEMOFusion Engineering and Design, 2015
- Improvement of non destructive infrared test bed SATIR for examination of actively cooled tungsten armour Plasma Facing ComponentsFusion Engineering and Design, 2013
- Development of an ultrasonic test method for the non-destructive examination of ITER divertor componentsFusion Engineering and Design, 2009
- High heat flux facility GLADIS:Journal of Nuclear Materials, 2007
- Hot radial pressing: An alternative technique for the manufacturing of plasma-facing componentsFusion Engineering and Design, 2005