Thermal-wave resonator cavity
Authors:
- 1 October 1995
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 66 (10) , 4999-5005
Abstract
A thermal‐wave resonant cavity was constructed using a thin aluminum foil wall as the intensity‐modulated‐laser‐beam induced oscillator source opposite a pyroelectric polyvilidene fluoride wall acting as a signal transducer and cavity standing‐wave‐equivalent generator. It was shown that scanning the frequency of oscillation produces the fundamental and higher overtone resonant extrema albeit with increasingly attenuated amplitude—a characteristic of thermal‐wave behavior. Experimentally, scanning the cavity length produced a sharp lock‐in in‐phase resonance with simple linewidth dependencies on oscillation (chopping) frequency and intracavity gas thermal diffusivity. The thermal diffusivity of air at 294 K was measured with three significant figure accuracy: 0.211±0.004 cm2/s. The novel resonator can be used as a high‐resolution thermophysical property sensor of gaseous ambients.Keywords
This publication has 5 references indexed in Scilit:
- Green’s functions in thermal-wave physics: Cartesian coordinate representationsJournal of Applied Physics, 1995
- A comparison between conventional photothermal frequency scan and the lock-in rate window method in measuring thermal diffusivity of solidsReview of Scientific Instruments, 1994
- Absolute nonradiative energy-conversion-efficiency spectra in : crystals measured by noncontact quadrature photopyroelectric spectroscopyPhysical Review B, 1993
- Thermal wave interferometry: a potential application of the photoacoustic effectApplied Optics, 1982
- Subsurface flaw detection in metals by photoacoustic microscopyaJournal of Applied Physics, 1980