Development and high stress abrasive wear behavior of milled carbon fiber‐reinforced epoxy gradient composites
Authors:
- 15 February 2008
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 29 (7) , 736-744
Abstract
Milled carbon fiber‐reinforced polysulfide‐modified epoxy gradient composites have been developed. Density and hardness increases with the increase of carbon fiber content in the direction of centrifugal force, which shows the formation of gradient structure in the composite. High stress abrasive wear test was conducted on the gradient composites by using a Suga Abrasion Wear Tester. Abrasive wear rate reduced on increase of milled carbon fiber content from 0.15 to 1.66 vol%. Reduction in abrasive wear rate in milled carbon fiber‐reinforced epoxy gradient composites has been attributed to the increase of hardness, presence of random milled fibers, and debris of composite materials, which gave resistance and reduced wear rate. There is a small decrease in specific wear rate on adding 0.15 vol% milled carbon fibers. Further decrease of specific wear rate is observed on adding 0.45 vol% milled carbon fibers. After 3 N load, there is a decrease in specific wear rate behavior on adding 0.45 vol% carbon fibers, which further decreases on adding 0.60 vol% of carbon fibers. There is a remarkable decrease in specific wear rate up to 5 N load for 1.66 vol% milled carbon fiber‐reinforced composite. Reduction in specific wear rate on adding milled carbon fibers is based on the formation of debris, which remained intact in their respective positions due to the interfacial adhesion between milled carbon fibers and epoxy resin. POLYM. COMPOS., 2008. © 2008 Society of Plastics EngineersKeywords
This publication has 18 references indexed in Scilit:
- Tribological behaviour of epoxy based composites for rapid toolingWear, 2006
- Sliding wear performance of polymer composites under abrasive and water lubricated conditions for pump applicationsWear, 2005
- Enhancement of the wear resistance of epoxy: short carbon fibre, graphite, PTFE and nano-TiO2Composites Part A: Applied Science and Manufacturing, 2004
- Rapid Prototyping2003
- Load, speed and temperature sensitivities of a carbon-fiber-reinforced phenolic friction materialWear, 1995
- On sliding friction and wear of PEEK and its compositesWear, 1995
- Fretting wear performance of glass-, carbon-, and aramid-fibre/epoxy and peek compositesWear, 1990
- The abrasive wear of short fibre compositesComposites, 1985
- Effect of fiber orientation on friction and wear of fiber reinforced polymeric compositesWear, 1979
- Wear Mechanism of Unidirectionally Oriented Fiber-Reinforced PlasticsJournal of Lubrication Technology, 1977