Characterization of the auto‐curing behavior of rapid prototyping materials for three‐dimensional printing using dielectric analysis
- 14 May 2015
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 55 (7) , 1485-1493
Abstract
Three‐dimensional printing technology applies the high efficiency of the ink jet printer technology to manufacture functional prototypes. To optimize the printing process of PMMA powder containing an initiator and a liquid binder consisting of polymerizable monomers with activator molecules, the knowledge of the curing kinetics is required. Therefore, a methodology was developed to apply dielectric analysis measuring changes of the ion and dipole mobility in terms of a quantity called ion viscosity. Connecting time‐dependent changes of ion viscosity and reaction heat determined by DSC leads to detailed insight into the curing process. The results show that the styrene concentration of the binder determines the curing kinetics—reduces thermal stresses and provides time for stress relaxation. The curing process differs significantly with respect not only to composition of the binder, but also to its aging state. The proposed approach can be implemented directly to a printer to detect dielectric changes of the materials during the manufacturing process. POLYM. ENG. SCI., 55:1485–1493, 2015. © 2015 Society of Plastics EngineersKeywords
Funding Information
- Netzsch Gerätebau GmbH and Operational Program Research and Development for Innovations (European Regional Development Fund [ERDF] and national budget of Czech Republic
- Centre of Polymer Systems (CZ.1.05/2.1.00/03.0111; B.H.))
This publication has 21 references indexed in Scilit:
- Dynamic monitoring of curing photoactive resins: A methods comparisonDental Materials, 2010
- The evolution of rapid prototyping in dentistry: a reviewRapid Prototyping Journal, 2009
- A new kinetic model for the photopolymerization shrinkage-strain of dental composites and resin-monomersDental Materials, 2006
- Hildebrand and Hansen solubility parameters from Molecular Dynamics with applications to electronic nose polymer sensorsJournal of Computational Chemistry, 2004
- Experimental investigation on cubic boron nitride turning of hardened AISI 52100 steelJournal of Materials Processing Technology, 2003
- Pervaporative dehydration of 1-methoxy propanol with acrylonitrile based co-polymer membranes prepared through emulsion polymerization: a solubility parameter approach and study of structural impactJournal of Membrane Science, 2002
- Eleventh International Conference on Composite Structures (ICCS/11), Monash University, Melbourne, Australia, November 2001Composite Structures, 2002
- Mechanical properties of dense polylactic acid structures fabricated by three dimensional printingJournal of Biomaterials Science, Polymer Edition, 1997
- Photopolymerization of dental composite matricesBiomaterials, 1994
- Maxillofacial prosthetics‐an international perspective of the British status quo*Journal of Oral Rehabilitation, 1992