Scaling of Film Cooling Performance From Ambient to Engine Temperatures
Authors:
- 1 July 2015
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 137 (7) , 071007
Abstract
The present study employs computational fluid dynamics (CFD) to explore the complexities of scaling film cooling performance measurements from ambient laboratory conditions to high temperature engine conditions. In this investigation, a single shaped hole is examined computationally at both engine and near ambient temperatures to understand the impact of temperature dependent properties on scaling film cooling performance. By varying select flow and thermal parameters for the low temperature cases and comparing the results to high temperature flow, the parameters which must be matched to scale film cooling performance are determined. The results show that only matching the density and mass flux ratios is insufficient for scaling to high temperatures. In accordance with convective heat transfer fundamentals, freestream and coolant Reynolds numbers and Prandtl numbers must also be matched to obtain scalable results. By virtue of the Prandtl number for air remaining nearly constant with temperature, the Prandtl number at ambient conditions is sufficiently matched to engine temperatures. However, laboratory limitations can prevent matching both the freestream and coolant Reynolds numbers simultaneously. By examining this trade-off, it is determined that matching the coolant Reynolds number produces the best scalability. It is also found that by averaging the adiabatic effectiveness of two experiments in which the freestream and coolant Reynolds number are matched, respectively, results in significantly better scalability for cases with a separated coolant jet.Keywords
This publication has 10 references indexed in Scilit:
- Full Coverage Effusion Cooling With a Narrow Duct Backside Coolant Supply2012
- Effusion-Cooling Performance at Gas Turbine Combustor Representative Flow Conditions2012
- Conjugate Heat Transfer Predictions of Effusion Cooling: The Influence of the Coolant Jet-Flow Direction on the Cooling Effectiveness2012
- Heat Release in Turbine Cooling II: Numerical Details of Secondary Combustion Surrounding Shaped HolesJournal of Propulsion and Power, 2011
- Heat Release in Turbine Cooling I: Experimental and Computational Comparison of Three GeometriesJournal of Propulsion and Power, 2011
- Correlation of Film-Cooling Effectiveness From Thermographic Measurements at Enginelike ConditionsJournal of Turbomachinery, 2002
- Film Cooling Effectiveness Due to Discrete Holes Within a Transverse Surface Slot2002
- Full-Coverage Film Cooling With Short Normal Injection HolesJournal of Turbomachinery, 2001
- The Effect of High Free-Stream Turbulence on Film Cooling EffectivenessJournal of Turbomachinery, 1996
- Experimental Investigation of Film Cooling With Ejection From a Row of Holes for the Application to Gas Turbine BladesJournal of Engineering for Power, 1975