Two-Dimensional Delamination Growth in Composite Laminates Under Compression Loading
Author:
- 1 January 1988
- book chapter
- Published by ASTM International
- p. 180-190
Abstract
A closed-form approximate solution for the total strain energy release rate (G) of an elliptically shaped delamination has been developed from thin-film assumptions that treat the delamination as a clamped plate subject to enforced boundary displacements. Approximate equations are derived which couple the large deflection membrane stresses to the out-of-plane deflections. The model restricts the boundary to remain elliptical as the delamination grows. By applying the simple failure criterion that rapid growth of the delamination (which occurs when G reaches a critical value) precipitates the final failure of the laminate, the predicted failure stresses can be correlated with post-impact strength data available in the literature. The Mode I critical G is required for a good correlation, although the model calculates the total G averaged around the perimeter. For impact damage, data on delamination depth are rarely available. However, it was found that by assuming a delamination interface that results in the lowest failure strain, correlation with test data was obtained.Keywords
This publication has 7 references indexed in Scilit:
- Delamination buckling and growth in a clamped circular plateAIAA Journal, 1988
- Ultimate axial load capacity of a delaminated beam-plateAIAA Journal, 1986
- The influence of lay-up and thickness on composite impact damage andcompression strength1985
- Axisymmetric buckling and growth of a circular delamination in a compressed laminateInternational Journal of Solids and Structures, 1985
- Two-Dimensional Modelling of Compressive Failure in Delaminated LaminatesJournal of Composite Materials, 1985
- Compression failure characteristics of + or - 45-deg-dominated laminates with a circular hole or impact damage1984
- One dimensional modelling of failure in laminated plates by delamination bucklingInternational Journal of Solids and Structures, 1981