Effect of initial temper on mechanical properties of friction stir welded Al-2024 alloy
Authors:
- V. DixitVDV. Dixit
- R. S. MishraR. S. Mishra
- R. J. LederichRLR. J. Lederich
- R. TalwarRTR. Talwar
- 1 May 2007
- journal article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 12 (4) , 334-340
Abstract
The microstructural evolution and resultant mechanical properties during the friction stir welding (FSW) of precipitation strengthened aluminium alloys depend on initial temper as well as FSW process parameters. Al-2024 alloy under two different initial tempers, T3 and T8, was used in the present study. FSW bead-on-plate runs were performed at different values of process parameters (tool rotation rate and tool traverse speed). Microstructure and mechanical properties of the nugget region and heat affected zone (HAZ) were evaluated. Differential scanning calorimetry (DSC) revealed that in the nugget region, presence of Guinier–Preston–Bagaryatskii (GPB) zone results from the partial dissolution of Al2CuMg phase. The microstructure and tensile properties were found to be independent of the initial temper of the material in the nugget region. In the HAZ region, tensile properties increased at higher heat index values for T3 condition, and decreased monotonically for T8 condition.Keywords
This publication has 12 references indexed in Scilit:
- Precipitation hardening in Al–Cu–Mg alloys revisitedScripta Materialia, 2006
- Friction stir welding and processingMaterials Science and Engineering: R: Reports, 2005
- Room temperature precipitation in quenched Al–Cu–Mg alloys: a model for the reaction kinetics and yield strength developmentPhilosophical Magazine, 2005
- Quantitative investigation of precipitation and mechanical behaviour for AA2024 friction stir weldsActa Materialia, 2005
- Correlation between microstructure and microhardness in a friction stir welded 2024 aluminium alloyScripta Materialia, 2005
- Thermomechanical Conditions and Resultant Microstructures in Friction Stir Welded 2024 AluminumMaterials Science Forum, 2003
- Origin of the initial rapid age hardening in an Al-1.7 at.% Mg-1.1 at.% Cu alloyPhilosophical Magazine Letters, 1999
- Origins of hardening in aged AlGuMg(Ag) alloysActa Materialia, 1997
- A quantitative interpretation of DSC experiments on quenched and aged SiCp reinforced 8090 alloysScripta Metallurgica et Materialia, 1995
- Hot WorkabilityInternational Metallurgical Reviews, 1972