Unveiling the Impact of the Polypyrrole Coating Layer Thickness on the Electrochemical Performances of LiNi 0.5 Co 0.2 Mn 0.3 O 2 in Li–Ion Battery
Authors:
- 31 May 2019
- journal article
- research article
- Published by Wiley in ChemistrySelect
- Vol. 4 (20) , 6354-6360
Abstract
Coating polypyrrole (PPy) on the surface of cathode materials could effectively enhance the electrochemical performances of lithium ion batteries (LIBs). The effect of the coated PPy layer thickness on the electrochemical performance, however, has not been well revealed. In this work, we study experimentally the impact of the PPy coating layer thickness on the electrochemical performance of the cathode materials in LIBs. The surface‐coated LiNi 0.5 Co 0.2 Mn 0.3 O 2 (NCM) with different PPy layer thickness was synthesized by in situ growing PPy on the surface of NCM. When these coated‐samples were tested as cathodes of LIBs, the sample PPy5 with a coating layer thickness of about 3 nm exhibits an optimum electrochemical performance. More detailed analysis of electrochemical impedance spectra and structures for the cycled electrodes show that the coating layer of about 3 nm endows the PPy5 cathode with the smallest resistance and the most stable structure, ensuring its excellent cycle stability and rate performance. Comparatively, coating layer thickness of about 1 nm is too thin to maintain the structural stability of PPy1 cathode during a long‐term cycle, and an over thick coating layer (approximately 5 nm) significantly increases the resistance due to the shedding of the electrode, which results in their poor electrochemical performance. The results given in present paper will provide the guidance for optimizing the electrochemical properties of conductive polymer coated cathode materials.Keywords
Funding Information
- National Natural Science Foundation of China (21571176, 21671077, 21771075, 21871106)
This publication has 51 references indexed in Scilit:
- Improvement of the Cycling Performance of LiNi0.6Co0.2Mn0.2O2 Cathode Active Materials by a Dual-Conductive Polymer CoatingACS Applied Materials & Interfaces, 2014
- Electrochemical Properties of Polyaniline-Coated Li-Rich Nickel Manganese Oxide and Role of Polyaniline Coating LayerJournal of the Electrochemical Society, 2013
- Electrochemical energy storage in a sustainable modern societyEnergy & Environmental Science, 2013
- Synthesize and electrochemical characterization of Mg-doped Li-rich layered Li[Li0.2Ni0.2Mn0.6]O2 cathode materialElectrochimica Acta, 2013
- A novel ion-conductive protection skin based on polyimide gel polymer electrolyte: application to nanoscale coating layer of high voltage LiNi1/3Co1/3Mn1/3O2 cathode materials for lithium-ion batteriesJournal of Materials Chemistry, 2012
- Synthesis and electrochemical characterization of LiFePO4/C-polypyrrole composite prepared by a simple chemical vapor deposition methodJournal of Solid State Electrochemistry, 2011
- Electrochemical characterization of polypyrrole–LiNi1/3Mn1/3Co1/3O2 composite cathode material for aqueous rechargeable lithium batteriesJournal of Solid State Electrochemistry, 2011
- Preparation and electrochemical properties of LiNi1/3Co1/3Mn1/3O2–PPy composites cathode materials for lithium-ion batterySynthetic Metals, 2011
- Challenges for Rechargeable Li BatteriesChemistry of Materials, 2009
- Optimized LiFePO4–Polyacene Cathode Material for Lithium‐Ion BatteriesAdvanced Materials, 2006