MEMS tunable Fabry-Perot Filters with thick, two sided optical coatings
Authors:
- 1 June 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 2159547X,p. 1357-1360
Abstract
A MEMS based tunable Fabry-Perot filter array has been designed and fabricated to provide spectral information in the long-wave infrared (LWIR) band, while remaining transparent in the mid-wave infrared (MWIR) band. Due to the stringent requirements on the optical design, relatively thick optical reflector and anti-reflector coatings are needed. A two-sided, SOI device layer transfer process has been developed to fabricate the thick coating layers and maintain a balanced stress state on the thin moveable membrane of the filter. Fabricated parts have less than 11 nm of deflection across a 200 mum filter. Measured filters show a <120 nm bandwidth peak in the LWIR that is tunable from 11.8 mum to 7.9 mum.Keywords
This publication has 4 references indexed in Scilit:
- Dual band adaptive focal plane array: an example of the challenge and potential of intelligent integrated microsystems2006
- Tuning in to DetectionSPIE Newsroom, 2004
- Charge control of parallel-plate, electrostatic actuators and the tip-in instabilityJournal of Microelectromechanical Systems, 2003
- A high Q, large tuning range MEMS capacitor for RF filter systemsSensors and Actuators A: Physical, 2003