Numerical Simulation of a Debris Flow on the Basis of a Two-Dimensional Continuum Body Model
Open Access
- 24 January 2020
- journal article
- research article
- Published by MDPI AG in Geosciences
- Vol. 10 (2) , 45
Abstract
A two-dimensional debris and mud flow model that considers both laminar and turbulence flow was developed. Subsequently, the model was applied to a debris flow that occurred in Asaminami, Hiroshima, Japan in August 2014. The applicability of the model and the debris flow characteristics are discussed. The calculated horizontal distribution of sediment deposited in the Asaminami residential area was in good agreement with the horizontal distribution of the deposited large rocks and driftwood. This result indicates that the fine material in the downstream area was transported by water flow resulting from heavy rain that occurred after the debris flow. The scale of the initial debris flow was small; however, it increased with time, because eroded bed material and water were entrained to it. Therefore, it is important to reproduce the development process of debris flows to predict the amount of sediment produced, the deepest flow depth, the maximum flow velocity, and the inundation area. The averaged velocity of the simulated debris flow was about 9 m/s, and the velocity at the entrance to the residential area was about 8 m/s. This kind of information can be used to design sediment deposition dams. The travel time of the simulated debris flow from the upstream end of the main channel to the entrance of the residential area was 96 s. This kind of information can be used for making evacuation plans. Valley bed steps can suppress the deepest flow depth which is very important for the design of check dams; therefore, the high-resolution elevation data and fine numerical grids that reproduce step shapes are required to accurately calculate the deepest flow depth and maximum flow velocity.Keywords
Funding Information
- Japan Ministry of Education (19K04615, 18K19951, 15H02267)
This publication has 25 references indexed in Scilit:
- RAMMS: Numerical simulation of dense snow avalanches in three-dimensional terrainCold Regions Science and Technology, 2010
- Description and numerical modelling of the October 2000 Nora debris flow, Northwestern Italian AlpsCanadian Geotechnical Journal, 2010
- A GIS-based numerical model for simulating the kinematics of mud and debris flows over complex terrainNatural Hazards and Earth System Sciences, 2009
- Erosion and morphology of a debris flow caused by a glacial lake outburst flood, Western NorwayLandslides, 2008
- GIS-based two-dimensional numerical simulation of rainfall-induced debris flowNatural Hazards and Earth System Sciences, 2008
- Avalanche mobility induced by the presence of an erodible bed and associated entrainmentGeophysical Research Letters, 2007
- Alpine debris flows triggered by a 28 July 1999 thunderstorm in the central Front Range, ColoradoGeomorphology, 2007
- Modelling tailings dams and mine waste dumps failuresGéotechnique, 2002
- Field observations of a debris flow event in the DolomitesGeomorphology, 1999
- Quantitative analysis of debris torrent hazards for design of remedial measuresCanadian Geotechnical Journal, 1984