Inorganic filler content of resin-based luting agents and the color of ceramic veneers
Open Access
- 7 June 2018
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Brazilian Oral Research
- Vol. 32, e49
Abstract
The influence of inorganic filler content of resin-based luting agents (RBLAs) on color change (ΔE00), CIEL*a*b* (individual color coordinates), and translucency parameters (TP) of simulated ceramic laminate veneer (CLV) was investigated. RBLAs with low, intermediate, and high inorganic filler content (55%, 65%, and 75% mass fractions, respectively) were prepared. Feldspar ceramic (Vitablocs Mark II) specimens (1.2 mm × 0.8 mm, A1C shade) were bonded to simulated composite resin substrates (1.6 mm × 1.2 mm, A2D shade) using three experimental and a commercial (RelyX Veneer) RBLA (translucent shade). The ΔE00 was calculated by CIEDE2000 color difference metric under three conditions (before, immediately after, and 24 h after luting). The TP was calculated using CIEL*a*b* color coordinates measured over white and black backgrounds. Surface morphology of the RBLAs was analyzed. One-way and two-way analyses of variance with a post-hoc Tukey’s test were used respectively to calculate TP, CIEL*a*b* coordinates, and ΔE00 (α= 0.05). Overall, the tested RBLAs presented clinically visible ∆E00 values under the three conditions evaluated. For all RBLAs, higher ∆E00 values were observed between measurements obtained before and immediately after luting. Different inorganic filler content did not significantly increase the opacity of the ceramic-luting agents-resin composite set. The variation in inorganic filler content did not influence significantly the TP of simulated CLV; although all of the experimental RBLAs tested yielded ∆E00 above the perceptibility threshold. The L*, a*, and b* individual color coordinates were cementation-dependent.Keywords
This publication has 37 references indexed in Scilit:
- Shade of Resin‐Based Luting Agents and Final Color of Porcelain VeneersJournal of Esthetic and Restorative Dentistry, 2016
- Esthetic Prosthetic Restorations: Reliability and Effects on Antagonist DentitionThe Open Dentistry Journal, 2015
- Resin-based luting agents and color stability of bonded ceramic veneersThe Journal of Prosthetic Dentistry, 2015
- Ceramic materials for porcelain veneers: Part II. Effect of material, shade, and thickness on translucencyThe Journal of Prosthetic Dentistry, 2014
- The effects of different shades of resin luting cement on the color of ceramic veneersDental Materials Journal, 2012
- Colour stability of laminate veneers: An in vitro studyJournal of Dentistry, 2011
- All-Ceramic Systems: Laboratory and Clinical PerformanceDental Clinics of North America, 2011
- Quantifying the Strength of a Resin-coated Dental CeramicJournal of Dental Research, 2008
- The Strengthening Mechanism of Resin Cements on Porcelain SurfacesJournal of Dental Research, 2006
- DENTIN-BONDED ALL-CERAMIC CROWNS: CURRENT STATUSThe Journal of the American Dental Association, 1998