Linear mixing in thermal infrared temperature retrieval
Authors:
- 1 September 2008
- journal article
- research article
- Published by Taylor & Francis in International Journal of Remote Sensing
- Vol. 29 (17-18) , 5047-5061
Abstract
Virtually all remotely sensed thermal infrared (IR) pixels are, to some degree, mixtures of different materials or temperatures: real pixels are rarely thermally homogeneous. As sensors improve and spectral thermal IR remote sensing becomes more quantitative, the concept of homogeneous pixels becomes inadequate. Quantitative thermal IR remote sensors measure radiance. Planck's Law defines a relationship between temperature and radiance that is more complex than linear proportionality and is strongly wavelength‐dependent. As a result, the area‐averaged temperature of a pixel is not the same as the temperature derived from the radiance averaged over the pixel footprint, even for blackbodies. This paper uses simple linear mixing of pixel elements (subpixels) to examine the impacts of pixel mixtures on temperature retrieval and ground leaving radiance. The results show that for a single material with one temperature distribution and with a subpixel temperature standard deviation of 6 K (daytime images), the effects of subpixel temperature variability are small but can exceed 0.5 K in the 3–5 µm band and about a third of that in the 8–12 µm band. For pixels with a 50 : 50 mixture of materials (two temperature distributions with different means) the impact of subpixel radiance variability on temperature retrieval can exceed 6 K in the 3–5 µm band and 2 K in the 8–12 µm band. Sub‐pixel temperatures determined from Gaussian distributions and also from high‐resolution thermal images are used as inputs to our linear mixing model. Model results are compared directly to these broadband thermal images of plowed soil and senesced barley. Finally, a theoretical framework for quantifying the effect of non‐homogeneous temperature distributions for the case of a binary combination of mixed pixels is derived, with results shown to be valid for the range of standard deviations and temperature differences examined herein.Keywords
This publication has 27 references indexed in Scilit:
- Extending surface temperature and emissivity retrieval to the mid-infrared (3–5 μm) using the Multispectral Thermal Imager (MTI)Remote Sensing of Environment, 2005
- Simulation Study of View Angle Effects on Thermal Infrared Measurements Over Heterogeneous SurfacesIEEE Transactions on Geoscience and Remote Sensing, 2004
- Simulation of scaling effects of thermal emission from non-isothermal pixels with the typical three-dimensional structureInternational Journal of Remote Sensing, 2003
- A temperature and emissivity separation algorithm for Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) imagesIEEE Transactions on Geoscience and Remote Sensing, 1998
- Skin temperature perturbations induced by surface layer turbulence above a grass surfaceWater Resources Research, 1998
- BRDF models to predict spectral reflectance and emissivity in the thermal infraredIEEE Transactions on Geoscience and Remote Sensing, 1998
- Remote sensing of land surface temperature: the directional viewing effectIEEE Transactions on Geoscience and Remote Sensing, 1997
- Surface temperature and emissivity at various scales: Definition, measurement and related problemsRemote Sensing Reviews, 1995
- Thermal remote sensing of land surface temperature from satellites: Current status and future prospectsRemote Sensing Reviews, 1995
- Infrared Reflectance from Mat SurfacesApplied Optics, 1968