Effects of heat treatment parameters on microstructural changes and corrosion behavior of Al 7075 Alclad alloy
Authors:
- M. Askari‐PaykaniMAM. Askari‐Paykani
- M. MeratianMMM. Meratian
- M. ShayanMSM. Shayan
- K. RaeissiKRK. Raeissi
- 8 September 2012
- journal article
- Published by Emerald Publishing in Anti-Corrosion Methods and Materials
- Vol. 59 (5) , 231-238
Abstract
Purpose: The purpose of this paper is to investigate the microstructural changes and stress corrosion cracking behavior via two‐stage stressing u‐bent tests for T6 and T73 tempers of Al 7075 Alclad alloy.Design/methodology/approach: Study was made of the effects of heat treatment; two‐stage stressing u‐bent, metallography, scanning electron microscopy, energy dispersive spectroscopy were employed.Findings: The results showed that the T6 heat treatment formed some very fine transgranular and coarse intergranular precipitates containing two compositions of (Fe/Cu/Si‐rich) and (Mg/Si‐rich) phases. The T73 treatment also precipitated some fine transgranular precipitates and coarse intermetallics with a (Fe/Cu‐rich) composition. In T6‐treated samples, stress corrosion cracking (SCC) occurred after 155 days due to the high susceptibility of the grain boundaries. In T73‐treated samples, the SCC did not occur even after 210 days. The dissolution of the Alclad layer in the corrosive media increased pH values and left the sample in the passivation region, protecting the sample from further corrosion attack.Originality/value: Based on microstructural and SCC resistance properties obtained by heat treatments, the T73 heat treatment with a tempering temperature of 107°C for seven hours as the first step and 170°C for 19 hours as the second step can be recommended for Al 7075 Alclad sheets.Keywords
This publication has 13 references indexed in Scilit:
- Effect of temper on the distribution of pits in AA7075 alloysCorrosion Science, 2008
- Influence of high-temperature pre-precipitation on local corrosion behaviors of Al–Zn–Mg alloyScripta Materialia, 2007
- Early-stage precipitation in Al–Zn–Mg–Cu alloy (7050)Acta Materialia, 2004
- Corrosion behaviour of different tempers of AA7075 aluminium alloyElectrochimica Acta, 2004
- GP-zones in Al–Zn–Mg alloys and their role in artificial agingActa Materialia, 2001
- Analysis of Precipitation and Dissolution in Overaged 7xxx Aluminium Alloys using DSCMaterials Science Forum, 2000
- Retrogression and re-ageing of 7075 aluminium alloy: microstructural characterizationJournal of Materials Processing Technology, 1999
- Stress-corrosion-cracking behavior of heat-treated Al−Zn−Mg−Cu alloy with temperatureMaterials Science, 1999
- Effect of microstructure on stress corrosion cracking of an Al-Zn-Mg-Cu alloyCorrosion Science, 1998
- Microstructures of the commercial 7075 Al alloy in the T651 and T7 tempersMetallurgical Transactions A, 1983