Diseño e Implementación de un Sistema de Control estable basado en Lógica Borrosa para optimizar el rendimiento de un sistema de Generación Fotovoltaico
Authors:
- Maissa FarhatMFMaissa Farhat
- Oscar BarambonesOscar Barambones
- Eladio DuranEladio Duran
- Jose M. AndujarJAJose M. Andujar
Open Access
- 1 October 2015
- journal article
- Published by Universitat Politecnica de Valencia in Revista Iberoamericana de Automática e Informática Industrial
- Vol. 12 (4) , 476-487
Abstract
ResumenEn este trabajo se presenta un nuevo esquema de control para un sistema fotovoltaico aislado (PV) utilizando un controlador de lógica borrosa (FLC). El sistema de control diseñado proporciona un buen seguimiento de la tensión de referencia óptima, a la cual se genera la máxima potencia. El sistema fotovoltaico está conectado a una carga a través de un convertidor CC/CC elevador (boost). El controlador FLC proporciona el ciclo de trabajo (D) apropiado al convertidor CC/CC para que el sistema PV genere la máxima potencia. También se propone un método de análisis de la estabilidad del sistema en lazo cerrado. Aunque el análisis de la estabilidad está basado en la metodología de Lyapunov, es un análisis semicualitativo, ya que no se dispone de un modelo del sistema en lazo cerrado para realizar un análisis analítico. Tanto los resultados de simulación como las pruebas experimentales sobre un sistema PV comercial muestran que el FLC proporciona un buen seguimiento del punto de máxima potencia (MPP). Finalmente, se ha evaluado el funcionamiento del FLC sobre un sistema PV real formado por unas placas fotovoltaicas comerciales Atersa modelo A55. Para realizar las pruebas experimentales se ha implementado la estrategia de control sobre un procesador digital de señal DS1104 de dSPACE. Los resultados experimentales obtenidos demuestran la validez del esquema de control FLC sobre un sistema fotovoltaico comercial.AbstractThis paper presents a new control scheme for a standalone photovoltaic (PV) system based on a fuzzy-logic (FLC). The proposed control system provides good tracking for the optimal reference voltage, at which the maximum power generation is obtained. The photovoltaic system is connected to a load through a DC/DC boost converter. The FLC controller provides the appropriate duty cycle (D) to the DC/DC converter in order to get the maximum power from the PV system. A method for the stability analysis of the closed-loop system is also proposed. The stability analysis is based on the Lyapunov methods and is a semi-qualitative analysis because there is no closed loop system model available for the analytical analysis. Both simulation results and experimental tests on a real PV system show that the FLC provides good tracking for the maximum power point (MPP).Finally, the performance of the FLC on a real PV system consisting of a commercial solar panels Atersa model A55 is analyzed. To perform the experimental tests the proposed control strategy has been implemented on the dSPACE digital signal processor model DS1104. The experimental results demonstrate the good performance of the proposed FLC control scheme over a commercial photovoltaic systeKeywords
This publication has 19 references indexed in Scilit:
- Photovoltaic Maximum Power Point Tracking Based on ANN ControlInternational Review on Modelling and Simulations (IREMOS), 2014
- Hibridación de sistemas borrosos para el modelado y controlRevista Iberoamericana de Automática e Informática Industrial, 2014
- Reference Voltage Optimizer for Maximum Power Tracking in Single-Phase Grid-Connected Photovoltaic SystemsJournal of Control and Systems Engineering, 2013
- Power management based on sliding control applied to fuel cell systems: A further step towards the hybrid control conceptApplied Energy, 2012
- Maximum power point tracking using fuzzy logic controlInternational Journal of Electrical Power & Energy Systems, 2012
- Comparison of fuzzy logic and neural network in maximum power point tracker for PV systemsElectric Power Systems Research, 2011
- Fuzzy-Logic-Control Approach of a Modified Hill-Climbing Method for Maximum Power Point in Microgrid Standalone Photovoltaic SystemIEEE Transactions on Power Electronics, 2010
- Maximum Power Point Tracking for Photovoltaic Optimization Using Ripple-Based Extremum Seeking ControlIEEE Transactions on Power Electronics, 2010
- Methodology and experimental system for measuring and displayingI–Vcharacteristic curves of PV facilitiesProgress in Photovoltaics: Research and Applications, 2009
- Control borroso multivariable basado en heurística. un caso práctico: grúa porta contenedoresRevista Iberoamericana de Automática e Informática Industrial, 2007