Two-Stage Approach for 12-V VR
Authors:
- 8 November 2004
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 19 (6) , 1498-1506
Abstract
To meet the stringent specifications of the voltage regulator (VR), the two-stage approach is proposed for the 12-V VR. This paper discusses detailed design considerations, which include the design of the first stage, optimization of the intermediate bus voltage, design of the intermediate bus capacitors, and the design of the ultra-high frequency second stage. The analysis shows that the two-stage approach can realize high frequency, thus significantly reducing the output capacitance and therefore decreasing the cost. A 1.2-V/100-A prototype is built to verify the analysis. The second stage runs at 2MHz per phase and the total efficiency is as high as 81%. Compared to the conventional single-stage multiphase buck, the two-stage approach is more cost-effective and more efficient.Keywords
This publication has 13 references indexed in Scilit:
- A Novel Winding-Coupled Buck Converter for High-Frequency, High-Step-Down DC–DC ConversionIEEE Transactions on Power Electronics, 2005
- Analysis of the Power Delivery Path From the 12-V VR to the MicroprocessorIEEE Transactions on Power Electronics, 2004
- Two-stage 48 V power pod exploration for 64-bit microprocessor2003
- A high efficiency topology for 12 V VRM-push-pull buck and its integrated magnetics implementations2003
- Design considerations for VRM transient response based on the output impedance2003
- Investigation of candidate VRM topologies for future microprocessors [voltage regulator modules]2002
- The active-clamp couple-buck converter-a novel high efficiency voltage regulator modules2002
- Optimal design of interleaved synchronous buck converter at high slew-rate load current transients2002
- Critical inductance in voltage regulator modulesIEEE Transactions on Power Electronics, 2002
- Design considerations for 12-V/1.5-V, 50-A voltage regulator modulesIEEE Transactions on Power Electronics, 2001