Damages and Microstructural Variation of High-lead and Eutectic SnPb Composite Flip Chip Solder Bumps Induced by Electromigration
Authors:
- 1 August 2005
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 20 (8) , 2184-2193
Abstract
The electromigration behavior of the high-lead and eutectic SnPb composite solder bumps was investigated at 150 °C with 5 × 103 A/cm2 current stressing for up to 1711 h. The diameter of the bumps was about 125 μm. The underbump metallization (UBM) on the chip side was sputtered Al/Ni(V)/Cu thin films, and the Cu pad on the board side was plated with electroless Ni/Au. It was observed that damages occurred in the joints in a downward electron flow (from chip side to the substrate side), while those joints having the opposite current polarity showed only minor changes. In the case of downward electron flow, electromigration damages were observed in the UBM and solder bumps. The vanadium in Ni(V) layer was broken under current stressing of 1711 h while it was still intact after current stressing of 1000 h. The electron probe microanalyzer (EPMA) elemental mapping clearly shows that the Al atoms in the trace migrated through the UBM into the solder bump during current stressing. Voids were found in the solder bump near the UBM/solder interface. The Sn-rich phases of the solder bumps showed gradual streaking and reorientation upon current stressing. This resulted in the formation of uniaxial Sn-rich phases in the middle of the solder bump, while the columnar and fibrous Sn-rich phases were formed in the surrounding regions. The formation mechanism of electromigration-induced damage to the UBM structure and solder bump were discussed.Keywords
This publication has 18 references indexed in Scilit:
- Failure behavior upon shear test of 5Sn–95Pb solder bump after high temperature reliability testJournal of Materials Research, 2004
- Thermomigration in Pb–Sn solder joints under joule heating during electric current stressingApplied Physics Letters, 2003
- Effect of Cu concentration on the interfacial reactions between Ni and Sn–Cu soldersJournal of Materials Research, 2002
- Current-crowding-induced electromigration failure in flip chip solder jointsApplied Physics Letters, 2002
- Electromigration of eutectic SnPb and SnAg3.8Cu0.7 flip chip solder bumps and under-bump metallizationJournal of Applied Physics, 2001
- The growth of intermetallic compounds at Sn-Ag-Cu solder/Cu and Sn-Ag-Cu solder/Ni interfaces and the associated evolution of the solder microstructureJournal of Electronic Materials, 2001
- Electromigration of eutectic SnPb solder interconnects for flip chip technologyJournal of Applied Physics, 2001
- The formation of Cu3Sn intermetallic on the reaction of cu with 95Pb-5Sn solderJournal of Electronic Materials, 1986
- Current-induced marker motion in gold wiresJournal of Physics and Chemistry of Solids, 1961
- Constitution of Binary AlloysJournal of the Electrochemical Society, 1958