Side Load-Transfer Mechanisms in Drilled Shafts in Soft Argillaceous Rock
Authors:
- 1 February 1997
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 123 (2) , 145-152
Abstract
Elastic-plastic axisymmetric finite-element analyses were performed to investigate the side load-transfer mechanism of drilled shafts socketed into cohesive intermediate geomaterials (very hard clays/very soft rocks). The roughness of the concrete-geomaterial interface was modeled explicitly by assuming sinusoidal undulations along a discontinuous surface. Smooth interfaces were also modeled. The results of the analyses indicated that the elastic response of rough sockets extends as the initial normal interface stress, σn, increases. Value σn does not affect the maximum unit side resistance, fmax, of sinusoidal sockets significantly, as shearing of the geomaterial occurs by gouging through the geomaterial asperities emanating from locations between the roots and crowns soon after separation occurs at the backs of the asperities. However, σn is a principal factor affecting fmax in smooth sockets. The sliding friction at the interface plays a major role in the development of load transfer, and internal fric...Keywords
This publication has 7 references indexed in Scilit:
- Towards an understanding of joint roughnessRock Mechanics and Rock Engineering, 1995
- Design of Socketed Drilled Shafts in LimestoneJournal of Geotechnical Engineering, 1992
- Shear Behavior of Regular Triangular Concrete/Rock Joints—AnalysisJournal of Geotechnical Engineering, 1989
- Theoretical solutions for axial deformation of drilled shafts in rockCanadian Geotechnical Journal, 1987
- Methods of improving the performance of drilled piers in weak rockCanadian Geotechnical Journal, 1983
- Side resistance rock sockets in sandstone, mudstone, and shaleCanadian Geotechnical Journal, 1981
- A finite element method for a class of contact-impact problemsComputer Methods in Applied Mechanics and Engineering, 1976