Fabrication of long glass fiber reinforced polyacetal composites: Mechanical performance, microstructures, and isothermal crystallization kinetics
Authors:
- 5 June 2014
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 36 (10) , 1826-1839
Abstract
A thermoplastic pultrusion was carried out to prepare the long fiber reinforced thermoplastic (LFT) composites based on polyacetal (POM) matrix on the custom‐designed pultrusion equipment. The investigation on mechanical performance revealed that the POM‐based LFT composites achieved much higher tensile, flexural, and impact strength than the short glass fiber reinforced ones at the same fiber loadings. Such a promising reinforcement effect is attributed to the feature that the residual fiber length in the injection‐molded LFT products is greatly superior to that in short fiber reinforced ones. This takes full advantage of the strength of the reinforcing fiber itself. The scanning electronic microscopy demonstrated that the fiber fracture and fiber pull‐out concurred on the tensile and impact fracture surfaces, and the former preceded the latter. The isothermal crystallization kinetics of the POM‐based LFT composites was also intensively studied, and the results indicated that the crystallinity of POM domain was enhanced by the heterogeneous nucleation of glass fiber, but the crystallization rate was postponed due to the interspace restriction toward crystalline growth caused by long glass fiber. These kinetic parameters provided information on the processing conditions of POM‐based LFT composites for the injection and compression molding. POLYM. COMPOS., 36:1826–1839, 2015. © 2014 Society of Plastics EngineersKeywords
Funding Information
- National Natural Science Foundation of China (51173010)
- National Key Basic Research Program (2012CB720304)
This publication has 47 references indexed in Scilit:
- A study on the melting and crystallization of polyoxymethylene‐copolymer/hydroxyapatite nanocompositesPolymers for Advanced Technologies, 2012
- Injection moulding of long glass fibre reinforced poly(ethylene terephtalate): Influence of carbon black and nucleating agents on impact propertiesExpress Polymer Letters, 2012
- Non-isothermal crystallization process of polyoxymethylene studied by two-dimensional correlation infrared spectroscopyPolymer, 2011
- Characterization of fatigue behavior of long fiber reinforced thermoplastic (LFT) compositesMaterials Characterization, 2009
- Analysis of layer-by-layer phase transformation of a polyoxymethylene copolymer filmActa Materialia, 2008
- Preparation and Mechanical Properties of Long Glass Fiber Reinforced PA6 Composites Prepared by a Novel ProcessMacromolecular Materials and Engineering, 2005
- Performance of long fiber reinforced thermoplastics subjected to transverse intermediate velocity blunt object impactComposite Structures, 2005
- Structural changes in non-isothermal crystallization process of melt-cooled polyoxymethylene[II] evolution of lamellar stacking structure derived from SAXS and WAXS data analysisPolymer, 2003
- Crystallization characteristics of polyoxymethylene with attapulgite as nucleating agentPolymer Engineering & Science, 2001
- Experiments on compression moulding and pultrusion of thermoplastic powder impregnated towpregsComposites Manufacturing, 1995