Sputtered Tungsten Oxide as Hole Contact for Silicon Heterojunction Solar Cells
Authors:
- 29 June 2017
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 7 (5) , 1209-1215
Abstract
Reactively sputtered tungsten oxide (WO x ) was investigated as hole contact on n-type crystalline silicon. Varying the oxygen gas flow during sputtering enables variation of the WO x conductivity from 0.01 to 1000 Ω/cm, while the band bending at the interface and the implied fill factor (FF) change by 70 meV and 1.5%. Sputtered WO x shows higher resistivity and higher absorption in the visible range compared with indium-tin-oxide (ITO). Therefore, stacks of WO x and ITO are used in solar cells. It was found that at least 20 nm thick WO x is needed to prevent detrimental effects of the ITO work function on the band bending at the junction, the implied FF, and the real FF of solar cells. WO x hole contacts of different thicknesses and conductivity were applied in solar cells and it was found that the highest FF is achieved using about 20 nm thick interlayers of WO x with the highest possible conductivity. It was found that sputtering enables a drastic improvement of WO x /silicon solar cells compared with thermal evaporation, due to the precise control of the WO x conductivity. Unfortunately, the resistivity of the sputtered WO x is still limiting the FF of these devices.Keywords
Funding Information
- European Commission through the Project NextBase (727523)
- ERASMUS PLUS program of the French ERASMUS agency
- Languedoc Roussillon Region
This publication has 28 references indexed in Scilit:
- Origin of passivation in hole-selective transition metal oxides for crystalline silicon heterojunction solar cellsJournal of Materials Research, 2016
- Oxygen vacancies in tungsten oxide and their influence on tungsten oxide/silicon heterojunction solar cellsSolar Energy Materials and Solar Cells, 2016
- Parasitic Absorption Reduction in Metal Oxide-Based Transparent Electrodes: Application in Perovskite Solar CellsACS Applied Materials & Interfaces, 2016
- Work Function Modification of Tungsten-Doped Indium Oxides Deposited by the Co-Sputtering MethodJournal of Nanoscience and Nanotechnology, 2016
- Transition metal oxides as hole-selective contacts in silicon heterojunctions solar cellsSolar Energy Materials and Solar Cells, 2016
- Molybdenum and tungsten oxide: High work function wide band gap contact materials for hole selective contacts of silicon solar cellsSolar Energy Materials and Solar Cells, 2015
- 22.5% efficient silicon heterojunction solar cell with molybdenum oxide hole collectorApplied Physics Letters, 2015
- Evaluation of metal oxides prepared by reactive sputtering as carrier-selective contacts for crystalline silicon solar cells2015
- TCO work function related transport losses at the a-Si:H/TCO-contact in SHJ solar cellsSolar Energy Materials and Solar Cells, 2014
- Electrochromic tungsten oxide films: Review of progress 1993–1998Solar Energy Materials and Solar Cells, 2000