Strengthening and embrittlement mechanisms in laser-welded additively manufactured Inconel 718 superalloy
Open Access
- 30 November 2024
- journal article
- research article
- Published by Springer Nature in Welding in the World
- Vol. 69 (1) , 81-98
Abstract
Although laser-welded additively manufactured Inconel 718 joints find numerous high-temperature industrial applications, their strengthening and embrittlement mechanisms remain underexplored. To bridge this gap, we herein prepared such joints by the laser welding of the as-built material (built-LW), laser welding of double-aging heat-treated as-built material (DAT-LW), and double-aging heat treatment of laser-welded as-built material (LW-DAT). The microstructures of the joint fusion zones (FZs) were examined using scanning electron microscopy (electron backscatter diffraction and secondary electron imaging), while nanoscale features were probed by transmission electron microscopy, and mechanical properties were evaluated using microindentation hardness (HIT) measurements and tensile tests. The FZs of the built-LW and DAT-LW joints contained no strengthening precipitates, such as the Laves phase and γ′ and γ″ nanoparticles. In stark contrast, the FZ of the LW-DAT joint contained spherical nanoparticles of the γ′ and γ″ phases responsible for precipitation hardening. The DAT-LW joint displayed base metal (BM) strengthening and FZ softening (HIT = 6.47 and 3.6 GPa, respectively), whereas the LW-DAT joint demonstrated BM and FZ strengthening (HIT = 6.2 and 6.5 GPa, respectively). The built-LW joint exhibited the lowest ultimate tensile strength (UTS) of 833 MPa, primarily because of the absence of strengthening precipitates. The DAT-LW joint, despite experiencing FZ softening, exhibited a higher UTS of 1086 MPa and a limited elongation of 2%, while the LW-DAT joint featured the highest UTS of 1440 MPa, primarily because of the enhancement of nanosized γ′ and γ″ strengthening phases facilitated by postwelding double-aging heat treatment.Keywords
Funding Information
- Business Finland (4795/31/2021)
- University of Oulu
This publication has 63 references indexed in Scilit:
- Microstructural characterization and oxidation performance of solution-annealed and precipitation hardened wire-arc additively manufactured Inconel 718 superalloysAdditive Manufacturing, 2022
- Additive manufacturing for energy: A reviewApplied Energy, 2021
- Enhancing mechanical properties of quasi-continuous-wave laser additive manufactured Inconel 718 through controlling the niobium-rich precipitatesAdditive Manufacturing, 2020
- A review of mechanical properties of additively manufactured Inconel 718Additive Manufacturing, 2019
- Effect of post-treatment on the microstructure and high-temperature oxidation behaviour of additively manufactured inconel 718 alloyCorrosion Science, 2019
- Effect of heat treatment on the microstructural evolution of a nickel-based superalloy additive-manufactured by laser powder bed fusionActa Materialia, 2018
- Alloy 718: Laser Powder Bed Additive Manufacturing for Turbine Applications2018
- The failure mechanism of 50% laser additive manufactured Inconel 718 and the deformation behavior of Laves phases during a tensile processThe International Journal of Advanced Manufacturing Technology, 2017
- Reduction of micro-cracking in nickel superalloys processed by Selective Laser Melting: A fundamental alloy design approachActa Materialia, 2015
- Microstructures and mechanical behavior of Inconel 718 fabricated by selective laser meltingActa Materialia, 2012