Numerical Assessment of Nanofluids in Recharging Microchannel: Thermo-Hydrodynamic and Entropy Generation Analysis
- 8 March 2021
- journal article
- research article
- Published by ASME International in Journal of Thermal Science and Engineering Applications
- Vol. 13 (5) , 1-45
Abstract
In this work three-dimensional numerical study is presented that deals with thermo-hydrodynamic performance and entropy generation in recharging microchannel using water-based nanofluids. Four different water-based nanofluids (Al2O3, CuO, SiO2, and ZnO) are considered with volume concentration and nanoparticle diameter varied in the range of 1% to 5%, and 10 nm to 50 nm respectively to understand their effect on thermo-hydrodynamic performance and entropy generation. Constant wall heat flux of 100 W/cm2 is applied on the substrate bottom surface while coolant flows through recharging microchannel with Reynolds number Re = 100 to 500. It is revealed that among all the nanofluids under investigation, water/Al2O3 provides enhanced thermal performance with higher effectiveness parameter (η), and it also shows reduced entropy generation in recharging microchannel. With increasing volume concentration of water/Al2O3 nanofluid, heat transfer coefficient increases, effectiveness parameter increases, and entropy generation reduces. Water/Al2O3 nanofluid with smaller particle diameter shows enhanced heat transfer coefficient, and reduced entropy generation, whereas it shows decreased effectiveness parameter. This is attributed to increased pressure drop with decreasing particle diameter. This study suggest that optimized combination of particle diameter and volume concentration should be chosen for using nanofluid based coolants for high heat flux removal.Keywords
This publication has 59 references indexed in Scilit:
- Convective performance of CuO/water nanofluid in an electronic heat sinkExperimental Thermal and Fluid Science, 2012
- The performance evaluation of Al2O3/water nanofluid flow and heat transfer in microchannel heat sinkInternational Journal of Heat and Mass Transfer, 2011
- Empirical correlating equations for predicting the effective thermal conductivity and dynamic viscosity of nanofluidsEnergy Conversion and Management, 2011
- Entropy generation due to flow and heat transfer in nanofluidsInternational Journal of Heat and Mass Transfer, 2010
- An experimental investigation of forced convective cooling performance of a microchannel heat sink with Al2O3/water nanofluidApplied Thermal Engineering, 2010
- Single-phase and two-phase cooling using hybrid micro-channel/slot-jet moduleInternational Journal of Heat and Mass Transfer, 2008
- Assessment of the effectiveness of nanofluids for single-phase and two-phase heat transfer in micro-channelsInternational Journal of Heat and Mass Transfer, 2007
- Microscale heat transfer enhancement using thermal boundary layer redeveloping conceptInternational Journal of Heat and Mass Transfer, 2005
- Conceptions for heat transfer correlation of nanofluidsInternational Journal of Heat and Mass Transfer, 2000
- HYDRODYNAMIC AND HEAT TRANSFER STUDY OF DISPERSED FLUIDS WITH SUBMICRON METALLIC OXIDE PARTICLESExperimental Heat Transfer, 1998