Determination of Diffusion Coefficients of Electroactive Species in Time-of-Flight Experiments Using a Microdispenser and Microelectrodes
- 2 May 2001
- journal article
- research article
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 73 (11) , 2468-2475
Abstract
Two novel methods for the determination of diffusion coefficients of redox species combining the special properties of microdispensing devices and microelectrodes are presented. Both are based on the local application of tiny volumes of the redox-active species by means of a dispenser nozzle at a defined distance from the surface of a microelectrode. The microelectrode, which is inserted through the bottom into an electrochemical cell, is held at a constant potential sufficient to oxidize or reduce the electro-active species under diffusional control. The dispenser, which is filled with the electro-active species, can be positioned by means of micrometer screws over the microelectrode. After dispensing a defined number of droplets near the microelectrode surface, the current through the microelectrode is recorded, usually yielding a peak-shaped curve having a defined time delay between the shooting of the droplets and the maximum current. The time that is necessary to attain maximum current, together with the known distance between two dispensing points, can be used to determine the diffusion coefficient of the electroactive species without knowledge of any system parameters, such as concentration of the redox species, diameter of the electroactive surface or number of transferred electrons. A similar method for the determination of diffusion coefficient of redox species involves a second redox species for calibration purposes. A mixture of both species is shot close to the microelectrode surface. Due to the different formal potentials of the redox species that are used, they can be distinguished in sequential experiments by variation of the potentials that are applied to the microelectrode, and it is thus possible to determine the individual transit times of the redox species independently. The difference in the transit times, together with the known diffusion coefficient of one of the redox species, can be used to calculate the unknown diffusion coefficient of the second one.Keywords
This publication has 11 references indexed in Scilit:
- Design and development of a silicon microfabricated flow-through dispenser for on-line picolitre sample handlingJournal of Micromechanics and Microengineering, 1999
- Picoliter Sample Preparation in MALDI-TOF MS Using a Micromachined Silicon Flow-Through DispenserAnalytical Chemistry, 1998
- MALDI on a Chip: Analysis of Arrays of Low-Femtomole to Subfemtomole Quantities of Synthetic Oligonucleotides and DNA Diagnostic Products Dispensed by a Piezoelectric PipetAnalytical Chemistry, 1997
- A flow-through microsampling device applied to an ion-exchange chromatography systemJournal of Biochemical and Biophysical Methods, 1993
- The determination of diffusion coefficients and rate constants from the dependence of the peak separation and peak current on the scan rate of cyclic voltammograms at micro-cylindrical electrodesJournal of Electroanalytical Chemistry and Interfacial Electrochemistry, 1991
- Direct determination of diffusion coefficients by chronoamperometry at microdisk electrodesJournal of Electroanalytical Chemistry and Interfacial Electrochemistry, 1991
- Direct measurements of the physical diffusion of redox active species: microelectrochemical experiments and their simulationThe Journal of Physical Chemistry, 1990
- An electrochemical time-of-flight experimentThe Journal of Physical Chemistry, 1987
- Micrometer-spaced platinum interdigitated array electrode: fabrication, theory, and initial useAnalytical Chemistry, 1986
- Linear sweep voltammetry at very small stationary disk electrodesJournal of Electroanalytical Chemistry and Interfacial Electrochemistry, 1984