Fabrication and Properties of Al-Cu-Mg-Zn Series Alloys with Low Hot Cracking Tendency for Liquid Forging
Authors:
Open Access
- 1 September 2017
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 230 (1) , 012036
Abstract
Twelve new kinds of Al-Cu-Mg-Zn alloys with different components were designed on the basis of optimizing main alloying elements, including Zn, Mg and Cu to resolve hot crack problems of Al-Cu-Mg-Zn series alloys during liquid forging. Hot cracking susceptibility (HCS) was adopted to characterize hot cracking tendency, evaluated using constrained rod casting in a steel mould. The influence of those three main alloying elements on the hot cracking tendency and the mechanical properties of new alloys were researched. The results show that most of those new alloys have better hot crack tendency performances than 2024 alloy and 7075 alloy. The 8th alloy, Al-5Cu-4.5Mg-2.5Zn, shows best mechanical properties after liquid forging, which hot crack tendency index is the lowest, only reaching 40. The tensile strength is 327 MPa and the elongation to fracture is 2.7%, which Brinell hardness reaches 107 N/mm2.Keywords
This publication has 3 references indexed in Scilit:
- Hot tearing of aluminum–copper B206 alloys with iron and silicon additionsMaterials Science and Engineering: A, 2010
- Microstructure and properties of high strength aluminium alloys for structural applicationsTransactions of the Indian Institute of Metals, 2009
- Hot cracking of binary Mg–Al alloy castingsMaterials Science and Engineering: A, 2006