Experimental Study of Counter-Doped Junction Termination Extension for 4H–SiC Power Devices
Authors:
- 30 April 2015
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Electron Device Letters
- Vol. 36 (7) , 699-701
Abstract
In this letter, a counter-doped junction termination extension (CD-JTE) structure was experimentally implemented and studied. Two groups of 4H-SiC PiN diodes were fabricated with two n-type drift layer thicknesses of 11 and 30 μm, respectively, and with different termination structures, in order to demonstrate the wide JTE dose tolerance of CD-JTE. Three different doses, 1.7 × 10 13 , 2.2×10 13 , and 2.8×10 13 cm -2 , were used for the critical JTE implantation. The measured breakdown voltages (BVs) of the diodes with all termination structures and JTE doses were compared with simulation predictions. Electroluminescence at the BV was recorded and used to locate the peak electrical field. The test results matched well with the simulation results. As a result of the effectiveness and robustness of the CD-JTE, the best achieved BVs from the diodes on the 11and 30-μm epilayers were 1850 and 4800 V, respectively.Keywords
Funding Information
- Washington State University Vancouver Mini Research Grant and Washington State University International Research Travel Award
- Ministry of Science and Technology (101-2628-E-007-013-MY3)
- U.S. Department of Commerce (BS123456)
This publication has 13 references indexed in Scilit:
- Counter-Doped JTE, an Edge Termination for HV SiC Devices With Increased Tolerance to the Surface ChargeIEEE Transactions on Electron Devices, 2014
- Breakdown Characteristics of 15-kV-Class 4H-SiC PiN Diodes With Various Junction Termination StructuresIEEE Transactions on Electron Devices, 2012
- High-Performance Smoothly Tapered Junction Termination Extensions for High-Voltage 4H-SiC DevicesIEEE Transactions on Electron Devices, 2011
- A New Edge Termination Technique for High-Voltage Devices in 4H-SiC–Multiple-Floating-Zone Junction Termination ExtensionIEEE Electron Device Letters, 2011
- Measurements of impact ionization coefficients of electrons and holes in 4H‐SiC and their application to device simulationPhysica Status Solidi (a), 2009
- Simulation and Experimental Study on the Junction Termination Structure for High-Voltage 4H-SiC PiN DiodesIEEE Transactions on Electron Devices, 2008
- Acceptor, compensation, and mobility profiles in multiple Al implanted 4H-SiCApplied Physics Letters, 2007
- Physical Modeling and Scaling Properties of 4H-SiC Power Devices2005
- Phosphorus implantation into 4H-silicon carbideJournal of Electronic Materials, 2000
- Ionization rates and critical fields in 4H silicon carbideApplied Physics Letters, 1997