Rogowski-Pair Sensor for High-Speed Switch Current Measurements without Reset Requirement
Authors:
- 9 October 2022
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Abstract
Amongst several existing non-invasive switch current measurement solutions, the PCB-embedded Rogowski coil has a few more advantages to be used for high-frequency, compact, and high-power designs, especially due to being air-cored. This is while, negligible low-frequency gain, as well as integrator circuit configuration, resulting in a droop for the Rogowski coil detector output. Increasing the nominal switching frequency to hundreds of kilohertz and above causes the droop issue to become much more complicated to tackle, such that, provisional solutions such as the addition of electronic reset would also be near impossible to implement, due to very small on-time. In this paper, a novel complementary PCB-embedded Rogowski-pair detector is proposed to remove the droop burden, while maintaining high-frequency performance. The main idea is to pair up identical coils and allocate one to detect the DC component of the measured switch-current, while the other coil measures a fully AC-coupled signal. Given the characteristics of the switch-current waveforms, an analog electronic circuit combines the two sensor outputs and compensates for the absence of the DC component measured by a normal Rogowski coil. A well-tuned Rogowski-pair was prototyped and tested to measure the switch current of a high-speed Silicon-Carbide (SiC) module.Keywords
Funding Information
- Oak Ridge National Laboratory
- University of North Carolina at Charlotte
This publication has 34 references indexed in Scilit:
- Comparison and Discussion on Shortcircuit Protections for Silicon-Carbide MOSFET Modules: Desaturation Versus Rogowski Switch-Current SensorIEEE Transactions on Industry Applications, 2020
- An Edge-Intelligent, Clip-on Rogowski Current Sensor With Wide Dynamic RangeIEEE Sensors Journal, 2019
- Integrator Design of the Rogowski Current Sensor for Detecting Fast Switch Current of SiC Devices2019
- A High-Speed Gate Driver with PCB-Embedded Rogowski Switch-Current Sensor for a 10 kV, 240 A, SiC MOSFET Module2018
- Study on the self-integration of a Rogowski coil used in the measurement of partial discharges pulsesElectrical Engineering, 2016
- Design of a high-bandwidth Rogowski current sensor for gate-drive shortcircuit protection of 1.7 kV SiC MOSFET power modules2015
- The Rogowski Coil Principles and Applications: A ReviewIEEE Sensors Journal, 2014
- Rogowski coil with an active integrator for measurement of switching impulse current2013
- Motor Fault Detection Using a Rogowski Sensor Without an IntegratorIEEE Transactions on Industrial Electronics, 2009
- An alternative low-cost current-sensing scheme for high-current power electronics circuitsIEEE Transactions on Industrial Electronics, 1995