A feedwater heater model intended for model-based diagnostics of power plant installations
Authors:
- Tomasz BarszczTBTomasz Barszcz
- Piotr CzopPCPiotr Czop
- 1 June 2011
- journal article
- Published by Elsevier in Applied Thermal Engineering
- Vol. 31 (8-9) , 1357-1367
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- A grid based multi-objective evolutionary algorithm for the optimization of power plantsApplied Thermal Engineering, 2010
- Experimental and numerical investigation of two-phase pressure drop in vertical cross-flow over a horizontal tube bundleApplied Thermal Engineering, 2009
- Dynamic modeling of steam power cycles: Part II – Simulation of a small simple Rankine cycle systemApplied Thermal Engineering, 2007
- The impact of fouling on performance evaluation of multi-zone feedwater heatersApplied Thermal Engineering, 2007
- Efficient design of feedwater heaters network in steam power plants using pinch technology and exergy analysisInternational Journal of Energy Research, 2007
- Transient Response of Two-Phase Heat Exchanger With Varying Convection CoefficientsJournal of Heat Transfer, 2006
- Fault Diagnosis for the Feedwater Heater System of a 300MW Coal-Fired Power Generating Unit Based on RBF Neural Network2006
- A simplified method of calculating heat flow through a two-phase heat exchangerApplied Thermal Engineering, 2005
- Enhancing the dynamic performance of electricity production in steam power plants by the integration of transient waste heat sources into the feed-water pre-heating systemInternational Journal of Energy Technology and Policy, 2005
- Sliding–window neural state estimation in a power plant heater lineInternational Journal of Adaptive Control and Signal Processing, 2001