Experimental Research and Analysis of a Novel Liquid Metal Fault Current Limiter
Authors:
- 30 April 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 28 (4) , 2566-2573
Abstract
This paper deals with the experimental research on a novel current limiter, which mainly takes advantage of the gas pressure in the liquid metal when arcing. A novel current-limiting principle is put forward on account of the pressure measurement results within an experimental device. According to this principle, a U-shape sliding part is designed and pushed upward under the gas pressure, which subsequently squeezes the arc into a narrow slot. Furthermore, a specially designed setup is employed to observe the moving process of the sliding part along with the arc behavior. It can be classified into three dynamic stages according to the frames obtained by a high-speed camera. The average velocity of the sliding part can reach about 11 m/s. Finally the influences on the current-limiting performance with the novel improved setup are explored and determined. It demonstrates that this novel method can enhance the current-limiting efficiency to some extent.Keywords
This publication has 23 references indexed in Scilit:
- The Development of the Arc in a Liquid Metal Current LimiterIEEE Transactions on Plasma Science, 2011
- Analysis of a New High-Speed DC Switch Repulsion MechanismIEICE Transactions on Electronics, 2011
- The effects of metal vapour in arc weldingJournal of Physics D: Applied Physics, 2010
- Experimental Investigation of Arc Plasma in GaInSn Liquid Metal Current-Limiting DeviceIEEE Transactions on Plasma Science, 2010
- Limitation of short circuit current by an IS-limiter2009
- Analysis of a Liquid Metal Current LimiterIEEE Transactions on Components and Packaging Technologies, 2009
- GaInSn usage in the research laboratoryReview of Scientific Instruments, 2008
- Comparison of electrical behaviour beetween the liquid metal current limiter and the low voltage melting fuse2007
- Analysis and Design of GaInSn Current Limiter2006
- Some Newly Observed Manifestations of Forces in the Interior of an Electric ConductorPhysical Review B, 1907