Experimental Investigation of Designed Parameters on Dimension Shrinkage of Injection Molded Thin-Wall Part by Integrated Response Surface Methodology and Genetic Algorithm: A Case Study
- 8 April 2011
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 26 (3) , 534-540
Abstract
Shrinkage plays an important role to evaluate the quality of molded plastics. In this article, dimension shrinkages of thin-wall molded part are investigated through experiments in the transverse and the longitudinal direction, simultaneously. Injection velocity, packing pressure, mold temperature and melt temperature are designed as processing parameters. Response surface methodology is adopted to develop the statistical models of dimension shrinkage. Results show that packing pressure is the most influential factor on the shrinkage variation in both directions, followed by mould temperature, injection velocity, and melt temperature. Based on the genetic algorithm technique, the optimal conditions of injection velocity, packing pressure, mold temperature, and melt temperature for minimum overall dimension shrinkage variations are 398.2 mm/s, 39.7 kgf/cm2, 69.8°C, and 239.9°C, respectively. Moreover, the error of overall dimension shrinkage between the predicted value and experimental measurement is about 7%. Through verification tests, the shrinkages are obviously improved about 85% and 63% in the transverse direction and the longitudinal direction, respectively.Keywords
This publication has 13 references indexed in Scilit:
- 3D study of cooling system effect on the heat transfer during polymer injection moldingInternational Journal of Thermal Sciences, 2010
- Review of utilization of genetic algorithms in heat transfer problemsInternational Journal of Heat and Mass Transfer, 2009
- Elitist Genetic Algorithm Models: Optimization of High Performance Concrete MixesMaterials and Manufacturing Processes, 2009
- Influence of EDM process parameters in deep hole drilling of Inconel 718The International Journal of Advanced Manufacturing Technology, 2007
- Modeling and optimization of designing parameters for a parallel-plain fin heat sink with confined impinging jet using the response surface methodologyApplied Thermal Engineering, 2007
- The use of Taguchi method in the design of plastic injection mould for reducing warpageJournal of Materials Processing Technology, 2007
- Application of Taguchi optimization technique in determining plastic injection molding process parameters for a thin-shell partMaterials & Design (1980-2015), 2007
- Modelling the machining parameters of wire electrical discharge machining of Inconel 601 using RSMJournal of Materials Processing Technology, 2005
- Determination of effecting dimensional parameters on warpage of thin shell plastic parts using integrated response surface method and genetic algorithmInternational Communications in Heat and Mass Transfer, 2005
- Efficient warpage optimization of thin shell plastic parts using response surface methodology and genetic algorithmThe International Journal of Advanced Manufacturing Technology, 2005