A Family of Zero-Voltage-Transition Bridgeless Power-Factor-Correction Circuits With a Zero-Current-Switching Auxiliary Switch
Authors:
- 28 June 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 58 (5) , 1848-1855
Abstract
A novel zero-voltage-transition high-efficiency bridgeless power-factor-correction (PFC) circuit with a zero-current-switching auxiliary switch was proposed, analyzed, and experimentally verified. An assist circuit, consisting of a resonant inductor, two blocking diodes, a clamping circuit, an autotransformer, and an auxiliary MOSFET switch, was used to reduce the turn-on switching loss of the two main switches of the bridgeless PFC circuit and the turn-off switching loss of the auxiliary switch. The soft commutation of the main switches is achieved without imposing an additional voltage stress on the main switches. Feedback gate-drive signals can be obtained by using an existing converter IC controller modified to fit the purpose. In this paper, a detailed description of the circuit operation will be given. Based on the analysis, the guidelines for the component selection are presented. A prototype of 100-kHz 600-W universal-line PFC bridgeless circuit was built to verify the proposed scheme. In addition, based on the same concept, a family of bridgeless PFC configuration was proposed.Keywords
This publication has 13 references indexed in Scilit:
- Zero-Current-Transition Bridgeless PFC Without Extra Voltage and Current StressIEEE Transactions on Industrial Electronics, 2009
- A novel one stage ZVS-PWM high frequency resonant inverter with boost single diode conducting mode passive ZCS-PFC scheme2008
- Proposal of a Soft-Switching Single-Phase Three-Level RectifierIEEE Transactions on Industrial Electronics, 2008
- A Novel Soft-Switching Boost PFC with a Passive Snubber2007
- High-power-factor soft-switched boost converterIEEE Transactions on Power Electronics, 2006
- Bridgeless PFC implementation using one cycle control technique2005
- A Novel ZCS-PWM Power-Factor Preregulator With Reduced Conduction LossesIEEE Transactions on Industrial Electronics, 2005
- State-of-the-Art, Single-Phase, Active Power-Factor-Correction Techniques for High-Power Applications—An OverviewIEEE Transactions on Industrial Electronics, 2005
- A high performance single phase AC to DC rectifier with input power factor correction2002
- A new ZVS-PWM unity power factor rectifier with reduced conduction lossesIEEE Transactions on Power Electronics, 1995