Influence of Heat Treatment on the Machinability of Titanium Alloys
- 1 April 2012
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 27 (4) , 457-461
Abstract
Orthogonal cutting force measurements and single-point tool life tests were conducted in order to analyze the sensitivity to heat treatment on the machinability of three titanium alloys: Ti6Al4V, Ti-5Al-4V-0.6Mo-0.4Fe (TIMETAL® 54M), and Ti6246. The Ti6246 alloy showed the highest tool wear rates and the higher cutting forces in all the heat treatment conditions which could be related to its higher mechanical properties. TIMETAL® 54M alloy, a newly developed alloy with similar mechanical properties to the more commonly used Ti6Al4V, showed the lowest wear rates. Microstructural changes due to heat treatment have some influence in the machinability of the alloys. The β annealed samples of the Ti6Al4V and TIMETAL® 54M alloys, with a very coarse lamellar microstructure, showed considerably shorter tool life and higher cutting forces. The rest of the heat treatments showed no significant influence in the machining behavior of the analyzed alloys as they do not cause important microstructural changes.Keywords
This publication has 8 references indexed in Scilit:
- Effect of Deep Cryogenic Treatment on Machinability of Titanium Alloy (Ti-6246) in Electric Discharge DrillingMaterials and Manufacturing Processes, 2010
- Comparison of the machinabilities of Ti6Al4V and TIMETAL® 54M using uncoated WC–Co toolsJournal of Materials Processing Technology, 2010
- Influence of cutting edge radius on cutting forces in machining titaniumCIRP Annals, 2010
- Machinability of titanium alloys (Ti6Al4V and Ti555.3)Journal of Materials Processing Technology, 2009
- Fuzzy Modeling and Analysis of Machining Parameters in Machining Titanium AlloyMaterials and Manufacturing Processes, 2008
- The Effect of Cutting Tool Material and Edge Geometry on Tool Life and Workpiece Surface IntegrityProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2006
- Tool wear characteristics in turning of titanium alloy Ti-6246Journal of Materials Processing Technology, 1999
- Tool Wear in Titanium MachiningCIRP Annals, 1982