Model of Particle Contact Area for Friction in Oxide Chemical Mechanical Polishing
Open Access
- 5 December 2019
- journal article
- research article
- Published by The Electrochemical Society in ECS Journal of Solid State Science and Technology
- Vol. 8 (12) , P787-P793
Abstract
Friction from Chemical Mechanical Polishing (CMP) of integrated circuits can cause damage to surface and sub-surface layers. To understand potentially damaging CMP friction, a model is presented which separates the contributions of: 1) bare pad asperity to substrate junction contacts, 2) slurry nanoparticles in the pad asperity contacts, and 3) a proposed substrate area where slurry particles adhere to and are swept along with the moving asperity contact. The model is used to interpret data from pin-on-disk friction experiments performed with a fused silica wafer and various polymer polishing pad materials, flooded with 100 nm diameter silica nanoparticle slurries. The results showed that only 18% of the pad asperity junction contact area had active particles and contacts outside of the asperity area were 38 times of the asperity junction area. This suggests that 93% of CMP material removal activity results from particles outside of the asperity/substrate contact.Keywords
This publication has 32 references indexed in Scilit:
- Strain and channel engineering for fully depleted SOI MOSFETs towards the 32 nm technology nodeMicroelectronic Engineering, 2007
- Damageless Cu chemical mechanical polishing for porous SiOC/Cu interconnectsMicroelectronic Engineering, 2007
- Chemical boundary lubrication in chemical–mechanical planarizationTribology International, 2005
- Chemical mechanical planarization for microelectronics applicationsMaterials Science and Engineering: R: Reports, 2004
- Peeling and delamination in Cu/SiLK™ process during Cu-CMPThin Solid Films, 2004
- Effects of Properties and Growth Parameters of Doped and Undoped Silicon Oxide Films on Wear Behavior During Chemical Mechanical Planarization ProcessJournal of Materials Research, 2004
- Two‐Dimensional Wafer‐Scale Chemical Mechanical Planarization Models Based on Lubrication Theory and Mass TransportJournal of the Electrochemical Society, 1999
- Chemical Mechanical Planarization of Microelectronic Materials1997
- Basic Science in Silica Glass PolishingMRS Proceedings, 1994
- Some speculations on the mechanisms of abrasive grinding and polishingPrecision Engineering, 1987