Characterization of Ti-35Nb-7Zr-5Ta Alloy Produced by Powder Metallurgy
- 1 November 2005
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 498-499, 34-39
Abstract
Titanium and titanium alloys present the highest biocompatibility among metallic biomaterials. The ideal titanium alloy for orthopedic applications should have low modulus of elasticity (near the bone), excellent mechanical strength, high corrosion resistance, formability and no potential toxic elements. Among titanium alloys, the Ti-35Nb-7Zr-5Ta alloy, due its high biocompatibility and lower Young’s modulus is a promising candidate for implants material. The titanium alloys production by powder metallurgy, starting from the elementary powders, is a viable route due at the smaller costs and larger operational facilities. The Ti-35Nb-7Zr-5Ta samples were manufactured by blended elemental method from a sequence of uniaxial and cold isostatic pressing with subsequent densification by sintering between 900 at 1700 °C, in vacuum, under a heating rate of 20 °C×min-1 for 1h. The objective of this work is the analysis of alloy microstructural evolution from the powders dissolution under the increase of the sintering temperature. For the alloy microstructural characterization, scanning electron microscopy and Vickers microhardness measurements, were used. Density was measured by Archimedes method. The samples presented high densification, an homogeneous microstructural development, with complete dissolution of alloying elements in the titanium matrix with the temperature increase.Keywords
This publication has 8 references indexed in Scilit:
- Microstructural evolution during hot pressing of the blended elemental Ti–6%Al–7%Nb alloyMaterials Science and Engineering: A, 2003
- Titanium release from dental implants: an in vivo study on sheepMaterials Letters, 2000
- In vivo metallic biomaterials and surface modificationMaterials Science and Engineering: A, 1999
- High-cycle fatigue performance of solution-treated metastable-β titanium alloysActa Materialia, 1999
- Titanium alloys in total joint replacement—a materials science perspectiveBiomaterials, 1998
- Materials selection and design for orthopaedic implants with improved long-term performanceBiomaterials, 1998
- IntroductionDiabetic Medicine, 1997
- Hydride-dehydride conversion of solid Ti6Al4V to powder formMaterials Characterization, 1996