Numerical Simulation of Flow Behaviour of PLA and PLA-Copper during Fused Deposition Modeling Process
Authors:
- 17 June 2022
- journal article
- research article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 1064, 53-63
Abstract
Fused deposition modeling (FDM) has been developed to adapt more application with a wide variety of material used, especially metal filled PLA filament. However, choosing wrong PLA-based filaments’ process parameters is a popular situation that causes great product’s dimensional error. This research is focused on studying the difference in the input velocity parameters between PLA and PLA-copper filament. This paper presents a numerical nozzle model and use finite element analysis method to investigate the melted filament fluid behavior. Flow parameters such as pressure, melting temperature range and velocity were discussed in detail. Experiments were then carried to determine optimal printing velocity range of the two filaments. Results show that the filament input velocity has great influence on flow parameters as this velocity changes, the flow parameters change as well. Finally, based on the evaluation of dimensional accuracy of printed samples, the optimal input velocity for each type of filament has been found, which are 2 – 3.5 mm/s for PLA and under 5 mm/s for PLA-copper.Keywords
This publication has 8 references indexed in Scilit:
- Computational analysis of the extrusion process of fused deposition modeling of acrylonitrile-butadiene-styreneInternational Journal of Material Forming, 2019
- Effect of Nozzle Geometry on Melt Flow Simulation and Structural Property of Thermoplastic Nanocomposites in Fused Deposition Modeling2017
- Design and Analysis of Fused Deposition Modeling 3D Printer Nozzle for Color MixingAdvances in Materials Science and Engineering, 2017
- ANALYZING THE EFFECT OF NOZZLE DIAMETER IN FUSED DEPOSITION MODELING FOR EXTRUDING POLYLACTIC ACID USING OPEN SOURCE 3D PRINTINGJurnal Teknologi (Sciences & Engineering), 2016
- Experimental and Computational Fluid Dynamic Analysis of Melt Flow Behavior in Fused Deposition Modelling of Poly(lactic) Acid2015
- Viscosity and viscoelasticity measurements of low density polyethylene/poly(lactic acid) blendsPolymer Bulletin, 2015
- A study of melt flow analysis of an ABS-Iron composite in fused deposition modelling processTsinghua Science and Technology, 2009
- Melt flow behaviour of poly-ε-caprolactone in fused deposition modellingJournal of Materials Science: Materials in Medicine, 2007