System power distribution network theory and performance with various noise current stimuli including impacts on chip level timing
Authors:
- 1 September 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 08865930,p. 621-628
Abstract
Power Quality has become a determining factor in product performance and reliability. The reactive portions of the power distribution network (PDN) have a greater effect on power quality than DC IR drop. Resonance in the parallel inductance and capacitance network creates an impedance peak in the frequency domain and undesirable voltage noise in the time domain. The on-chip voltage noise is usually much higher than PCB PDN noise. A method of determining and simulating circuit parameters and comparing results to a target impedance is presented. A test vehicle has been built and measured to provide laboratory measured results for PDN voltage noise. Switching current patterns are defined which generate typical and pathological voltage waveforms. PRBS patterns are used as a characterization technique to provide reasonable worst case resonance stimulation. The voltage noise is responsible for measured timing and jitter degradation in logic circuits.Keywords
This publication has 2 references indexed in Scilit:
- Mid-frequency delta-I noise analysis of complex computer system boards with multiprocessor modules and verification by measurementsIEEE Transactions on Advanced Packaging, 2001
- Power distribution system design methodology and capacitor selection for modern CMOS technologyIEEE Transactions on Advanced Packaging, 1999