Crack analysis near vacuum brazing interface of Cu/Al dissimilar materials using Al–Si brazing alloy
Authors:
- C. Z. XiaCXC. Z. Xia
- Y. J. LiYLY. J. Li
- U. A. PuchkovUPU. A. Puchkov
- S. A. GerasimovSGS. A. Gerasimov
- J. WangJWJ. Wang
- 1 March 2009
- journal article
- research article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 25 (3) , 383-387
Abstract
The present paper concentrates on the factors inducing cracking near the Cu/Al vacuum brazing interface using Al–Si brazing alloy. Various analysis and test methods were adopted to analyse the cause of the cracking. Experiment results indicated that two intermetallic compounds layers – δ phase and θ phase – were formed near the interface of Cu and brazing seam region. The microhardness of both the two intermetallic compounds phases reached 720 and 510 HM respectively. The brazing seam region consisted mainly of θ phase and α-Al (Cu) solid solution. Si presence had led to obvious zone liquation in the brazing seam region. Stress concentration appeared on the margin and edge region of the joint. The crack initiated on the θ phase layer, and then extended towards the brazing seam region and δ phase layer. The separation in the θ phase had an obviously brittle fracture surface.Keywords
This publication has 7 references indexed in Scilit:
- Microstructural evolution in the friction stir welded 6061 aluminum alloy (T6-temper condition) to copperJournal of Materials Processing Technology, 2006
- Characterisation of dissimilar joints in laser welding of steel–kovar, copper–steel and copper–aluminiumMaterials Science and Engineering: A, 2004
- Laser brazing of aluminiumJournal of Materials Processing Technology, 2003
- Effects of Cu/Al intermetallic compound (IMC) on copper wire and aluminum pad bondabilityIEEE Transactions on Components and Packaging Technologies, 2003
- Solid state Si diffusion and joint formation involving aluminum brazing sheetMaterials Science and Engineering: A, 2002
- Growth rate of intermetallic compounds in Al/Cu bimetal produced by cold roll welding processJournal of Alloys and Compounds, 2001
- Friction welding of StAl and AlCu materialsJournal of Materials Processing Technology, 1995