Enhancing Battery Available Operating Time (BAOT) via a Passive Series-PCM and Optimized Finned Structures
Open Access
Abstract
Keeping the battery temperature below a reasonable limit of 50 °C is a primary objective of battery thermal management systems (BTMSs). Accordingly, the battery available operating time (BAOT) can be defined as the time required for the battery maximum temperature to reach 50 °C, which could be adopted as a key indicator for safe and efficient operation. BAOT can be improved through different BTMS configurations. This work focuses on passive solutions, aiming to increase BAOT without requiring pumping power. The study numerically investigates the combined use of phase change materials (PCMs) and fins to evaluate their effectiveness in terms of time percentage improvement (TPI). A preliminary analysis is conducted to assess the need for PCMs and fins at three discharge rates, namely 1C, 3C, and 5C. The results indicate that PCMs are required under all operating conditions, while the use of fins is not always advantageous; in particular, at 1C, fins lead to a reduction in BAOT. The analysis then focuses on the 3C and 5C cases, where topology-optimized fins are employed to dump temperatures under these stress conditions. Three fin arc lengths (ψfin) and eight diffusion coefficients (Rf) are examined. The optimized fin configurations increase BAOT, achieving maximum TPIs of 10.61% and 7.69% for the 3C and 5C cases, respectively, both corresponding to ψfin = 2.75 mm and Rf = 0.10 mm. At 5C, BAOT is limited to only a few seconds; therefore, configurations with PCMs arranged in series are also analyzed using different combinations of four selected PCMs. When coupled with optimized fins, the PCM-in-series solutions yield further improvements, with maximum TPIs of 22.92% for 3C and 62.50% for 5C compared to the single-PCM configuration coupled with optimized fins. The results also show that the optimal diffusion coefficient and PCM arrangement strongly depend on the discharge rate.Keywords
Funding Information
- Italian Government MUR (P2022NYPHL–PRIN 2022 PNRR)
This publication has 18 references indexed in Scilit:
- Numerical investigation for a coupled fin-PCM-liquid cooling system under multi-scenario of thermal management and thermal runaway mitigation in lithium-ion battery modulesJournal of Energy Storage, 2025
- Performance improvement of a hybrid battery thermal management system with pseudo-3D topology optimizationInternational Journal of Heat and Mass Transfer, 2024
- Thermal management optimization strategy for lithium-ion battery based on phase change material and fractal finJournal of Energy Storage, 2024
- Performance analysis of a battery thermal management system based on phase change materials with micro heat pipe arraysEnergy Conversion and Management, 2024
- Measurement of thermophysical parameters and thermal modeling of 21,700 cylindrical batteryJournal of Energy Storage, 2023
- Rechargeable batteries: Technological advancement, challenges, current and emerging applicationsEnergy, 2022
- A review of thermal runaway prevention and mitigation strategies for lithium-ion batteriesEnergy Conversion and Management: X, 2022
- Experimental comparative analysis of finned-tube PCM-heat exchangers’ performanceApplied Thermal Engineering, 2022
- Transient three-dimensional thermal model for batteries with thin electrodesJournal of Power Sources, 2013
- Topology optimization approachesStructural and Multidisciplinary Optimization, 2013