Effects of Slitting Size and Inlet Operating Conditions on Hydrogen Combustion Characteristics in a Micro-Combustor With a Controllable Vortex Slotted Bluff Body
- 14 November 2019
- journal article
- research article
- Published by Wiley in Journal of Energy Resources Technology
- Vol. 142 (4) , 1-32
Abstract
Effects of controllable vortex slotted bluff body parameters (position of a bluff body, slit size, and controllable flow ratio) on the combustion characteristics of hydrogen/air in a micro-combustor with a bluff body were investigated numerically. The results illustrated that the combustion efficiency of hydrogen decreases with increasing distance (L1) between the front edge of the bluff body and the combustor inlet. The combustion characteristics of the micro-combustor are optimum when L1 is 0 mm. The blow-off limit of the combustor reaches a maximum (564 cm3/s) when the slit width (d) is 20% of the bluff body width. The blow-off limit first increases and then decreases when the equivalence ratio (φ) increases and reaches a maximum (732 cm3/s) when φ is 1.0, and the controllable flow ratio is 0.2. The combustion efficiency of hydrogen is gradually increased with the increase in the controllable flow ratio. When φ is less than 1.0, the optimal controllable flow ratio gradually decreases with the increase in the premixed gas flow rate, and the optimal controllable flow ratio basically remains at 0.6 when the premixed gas flow rate is less than 360 cm3/s.Keywords
Funding Information
- National Natural Science Foundation of China (51876014)
This publication has 32 references indexed in Scilit:
- Thermal performance of a micro combustor with heat recirculationFuel Processing Technology, 2013
- Microscale combustion: Technology development and fundamental researchProgress in Energy and Combustion Science, 2011
- Micro and mesoscale combustionProceedings of the Combustion Institute, 2011
- Experimental study on premixed CH4/air mixture combustion in micro Swiss-roll combustorsCombustion and Flame, 2010
- Experimental investigation of porous media combustion in a planar micro-combustorFuel, 2010
- Approximate solutions of lean premixed combustion in porous media with reciprocating flowInternational Journal of Heat and Mass Transfer, 2009
- Near-Blowoff Dynamics of a Bluff-Body Stabilized FlameJournal of Propulsion and Power, 2007
- Numerical modeling of non-adiabatic heat-recirculating combustorsProceedings of the Combustion Institute, 2007
- Flame stabilization and emission of small Swiss-roll combustors as heatersCombustion and Flame, 2005
- Combustion in micro-cylindrical combustors with and without a backward facing stepApplied Thermal Engineering, 2002