On Optimizing the Aerodynamic Load Acting on the Turbine Shaft of PMSG-Based Direct-Drive Wind Energy Conversion System
Authors:
- 30 October 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 61 (8) , 4022-4031
Abstract
The blade's rotational sampling to the spatial distributed wind velocities will induce 3P oscillating aerodynamic torque during the wind energy generation process. This causes the turbine drive train bare high aerodynamic load because the generator is driven by this aerodynamic torque through it. Moreover, the system's inherent resonant mode will be also induced by the aerodynamic load, causing fatal damage to the whole system. To damp the serious aerodynamic load of the permanent-magnet-synchronous-generator-based direct-drive wind energy conversion system (WECS), a new power control strategy with damping injection is proposed in this paper. The proposed method is realized by adding a compensation torque, which is proportional to the small-signal value of the generator speed, into the system torque control loop. Both the aerodynamic load and the system's inherent resonant mode could be well damped if the proposed method were adopted. Theoretic analysis is verified by experimental results performed by a 10-kW WECS established in the laboratory.Keywords
This publication has 19 references indexed in Scilit:
- Wind Energy System With Integrated Functions of Active Power Transfer, Reactive Power Compensation, and Voltage ConversionIEEE Transactions on Industrial Electronics, 2012
- Control Structure for Single-Phase Stand-Alone Wind-Based Energy SourcesIEEE Transactions on Industrial Electronics, 2012
- A sensorless control method for variable-speed small wind turbinesRenewable Energy, 2012
- Overview of Multi-MW Wind Turbines and Wind ParksIEEE Transactions on Industrial Electronics, 2011
- A Novel Control Strategy for a Variable-Speed Wind Turbine With a Permanent-Magnet Synchronous GeneratorIEEE Transactions on Industry Applications, 2009
- Comparative study on transient stability analysis of wind turbine generator system using different drive train modelsIET Renewable Power Generation, 2007
- Wind Turbine Control Systems2007
- Simulation Model of Wind Turbine 3p Torque Oscillations due to Wind Shear and Tower ShadowIEEE Transactions on Energy Conversion, 2006
- Co‐ordinated voltage control of DFIG wind turbines in uninterrupted operation during grid faultsWind Energy, 2006
- Analysis of a power oscillation damping scheme using a voltage-source inverterIEEE Transactions on Industry Applications, 2002