The combined effect of process variations and power supply noise on clock skew and jitter
Authors:
- 1 March 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19483287,p. 320-327
Abstract
In modern VLSI circuits, a large number of clock buffers are inserted in clock distribution networks, which are significantly affected by process and power supply noise variations. The combined effect of process variations and power supply noise on clock skew and jitter is investigated in this paper. A statistical model of skitter, which consists of skew and jitter, is proposed. Clock paths with different buffer insertion strategies are compared in terms of skew and jitter. The tradeoffs among the constraints on clock jitter, skew, slew rate, and power are discussed. For strict timing constraints, severe power overhead (≥110%) has to be added to obtain a low improvement in the worst case skitter and slew rate (≤13%). The effect of widely-used techniques, such as recombinant trees and dynamic voltage scaling, on decreasing skitter is also investigated.Keywords
This publication has 22 references indexed in Scilit:
- Circuit Design and Modeling Techniques for Enhancing the Clock-Data Compensation Effect Under Resonant Supply NoiseIEEE Journal of Solid-State Circuits, 2010
- Statistical Timing Analysis Considering Clock Jitter and Skew due to Power Supply Noise and Process VariationIEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences, 2010
- Tribeca2009
- Fast Buffer Insertion for Yield Optimization Under Process Variations2007
- On-chip timing uncertainty measurements on IBM microprocessors2007
- Enhancing Microprocessor Immunity to Power Supply Noise With Clock-Data CompensationIEEE Journal of Solid-State Circuits, 2006
- Statistical timing analysis under spatial correlationsIEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems, 2005
- Statistical timing analysis for intra-die process variations with spatial correlations2003
- Impact of die-to-die and within-die parameter fluctuations on the maximum clock frequency distribution for gigascale integrationIEEE Journal of Solid-State Circuits, 2002
- Coping with buffer delay change due to power and ground noise2002