Enhancing Wear Resistance of Selective Laser Melted Parts: Influence of Energy Density
Authors:
- 8 June 2020
- journal article
- research article
- Published by ASME International in Journal of Tribology
- Vol. 142 (11)
Abstract
Selective laser melting (SLM) is a rapidly developing metal additive manufacturing technology. SLM process parameters have a direct impact on the microstructure of parts, which further affect wear behaviors. Increasing the wear resistance by tailoring process parameters, instead of postprocessing, is crucial for enhancing surface properties of the SLM-fabricated parts with complicated structures. In this study, 316L stainless steel samples were fabricated using different energy densities by varying hatch spacing and scanning speed. The relative density and hardness were measured, and the microstructures were examined. The wear resistance was evaluated by performing scratch tests. Results show that high hardness was found in the bottom region of the samples by small hatch spacings and the highest hardness of 302.8 ± 4.3 HV was measured in the sample by a hatch spacing of 10 μm. With the increase of energy density from 178 to 533 J/mm3 by reducing hatch spacing, the fraction of cellular structures decreases and columnar structures are more likely to be aligned in a relatively constant tilted angle from the build direction, which significantly improve the ability to resist slipping and deformation, indicated by 90.1%, 45.0%, and 15.7% reductions in wear rates under 1, 3, and 5 N, respectively. With the increase of energy density from 182 to 545 J/mm3 by reducing the scanning speed, the number of cellular structures increases but pores also form, which negatively affects wear resistance.Keywords
Funding Information
- National Natural Science Foundation of China (51775486, 51890881)
- National Key Research and Development Program of China (2018YFB2000704)
This publication has 41 references indexed in Scilit:
- Selective laser melting additive manufacturing of Inconel 718 superalloy parts: Densification, microstructure and propertiesJournal of Alloys and Compounds, 2014
- The study of the laser parameters and environment variables effect on mechanical properties of high compact parts elaborated by selective laser melting 316L powderMaterials Science and Engineering: A, 2013
- Strong morphological and crystallographic texture and resulting yield strength anisotropy in selective laser melted tantalumActa Materialia, 2013
- Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powderActa Materialia, 2013
- Correlation between wear resistance and subsurface recrystallization structure in copperWear, 2012
- Densification behavior, microstructure evolution, and wear performance of selective laser melting processed commercially pure titaniumActa Materialia, 2012
- Comparisons of dry sliding tribological behaviors between coarse-grained and nanocrystalline copperWear, 2012
- Microstructure and mechanical properties of Selective Laser Melted 18Ni-300 steelPhysics Procedia, 2011
- A study of the microstructural evolution during selective laser melting of Ti–6Al–4VActa Materialia, 2010
- Effect of grain size on wear behaviour of alumina cutting toolsWear, 1997