Structural and chemical comparison between moderately oxygenated and edge oxygenated graphene: mechanical, electrical and thermal performance of the epoxy nanocomposites
Open Access
- 25 September 2019
- journal article
- research article
- Published by Springer Nature in SN Applied Sciences
- Vol. 1 (10) , 1275
Abstract
Two different graphitic powders, namely: moderately-oxidized graphene oxide (mGO) synthesized via a chromium-based technique and a commercial edge-oxidized graphene oxide (eGO), were characterized and incorporated into an epoxy resin, suitable for wind turbine blade structural components. Raman spectroscopy, X-ray photoelectron spectroscopy and thermogravimetric analysis revealed low oxygen content, but divergent structural characteristics for both powders confirming the increased basal-plane functionality of mGO compared to the peripherally decorated eGO. It is also shown that the eGO, displays carbon-based impurities. The inclusion of mGO, into the epoxy resulted in an initial glass transition temperature (Tg) increase (~ 5 °C at 4.4 vol.% mGO) but thereafter Tg decreased sharply. On the contrary, the inclusion of eGO resulted only in a progressive Tg increase. Introduction of just 1 vol.% of eGO deteriorated the tensile strength (~ 15% reduction) of the epoxy, while the strength of the mGO-filled samples was retained. Inclusion of mGO results in a percolation threshold (increase from 4.6 × 10−16 to 6 × 10−9 S/cm) at 0.53 vol.%; in contrast, at the same filler content, the eGO-filled systems are characterized by drastically lower conductivity values (3.4 × 10−16 S/cm). Nevertheless, further analysis indicates similar intrinsic conductivity (~ 10−6 S/cm) for the two fillers. Finally, the maximum achieved thermal conductivity increase with mGO was 200% (at 9.13 vol.%) compared with the unfilled epoxy, while the respective increase with eGO was 150% (at 18 vol.%).Keywords
Funding Information
- Horizon 2020 (642771)
This publication has 41 references indexed in Scilit:
- Tailoring the electrical and thermal conductivity of multi-component and multi-phase polymer compositesInternational Materials Reviews, 2019
- Harnessing the chemistry of graphene oxideChemical Society Reviews, 2014
- A review on polymer–layered silicate nanocompositesProgress in Polymer Science, 2008
- Processing of nanographene platelets (NGPs) and NGP nanocomposites: a reviewJournal of Materials Science, 2008
- Polymer nanotechnology: NanocompositesPolymer, 2008
- Use of exfoliated graphite filler to enhance polymer physical propertiesCarbon, 2007
- Evaluation and identification of electrical and thermal conduction mechanisms in carbon nanotube/epoxy compositesPolymer, 2006
- The continuing evolution of semiconductor materials for power cable applicationsIEEE Electrical Insulation Magazine, 2005
- Thermal degradation behaviour of PE/clay nanocompositesPolymer Degradation and Stability, 2004
- In situ network structure, electrical and thermal properties of conductive epoxy resin–carbon black composites for electrical heater applicationsMaterials Letters, 2002